Can a camshaft failure be a front wheel drive problem?
Camshaft failure is a major repair for any type of engine design, whether it be overhead valve (OHV) or overhead cam (OHC). It doesn’t matter if the engine is a rear wheel drive (RWD) vehicle or one that is front wheel drive (FWD), this job is going to take some time.
How do you remove a camshaft from an engine?
Mark the rocker arms before the camshaft is removed. Remove the bearing cap bolts, the bearing caps and the camshafts. Remove the rocker arms. Lubricate the cam followers with clean engine oil before installation. Position each cam follower onto the valve lifter and valve stem.
When do you replace the camshaft and follower?
Let’s review the replacement of the camshaft and rocker arms (commonly referred to as cam followers) in the 3.6L V6 VVT engine, also known as the Pentastar® engine. This engine is used across the board in FCA US LLC’s vehicle lineup, so you’ll find it in Minivans, Chrysler 200, 300C, Dodge Challenger,…
What happens if you dont change the oil in an exhaust cam actuator?
If you don’t change your oil on a regular basis, gunk buildup will form and block oil flow into the actuator. The PCM notices the camshaft didn’t adjust as it was intended to and sets a trouble code related to the actuator solenoid.
What should I do if I have a camshaft failure?
For extra protection, an anti-wear additive should be added, such as Crane Super Lube. Do not use synthetic oil during the break-in period. It is not recommended to use any type of oil restrictors to the lifter galley, or use windage trays, baffles,or plug any oil return holes in the valley.
Can you replace a camshaft position sensor yourself?
Can You Replace a Camshaft Position Sensor Yourself? My response to this question is yes. And that is because it is one the easiest car maintenance job anyone can do and save money. How long does it take to replace a camshaft sensor? Replacing a camshaft sensor does take too long to replace.
Can a bad camshaft sensor cause hard shifting?
Answer: Yes, a faulty camshaft position sensor can cause hard shifting or lock a gear in place. Question: When I start on a cold engine everything is fine, but after a minute the engine begins to cough, and there is a malfunction on the camshaft sensor.
Where is the solenoid on a camshaft?
A camshaft actuator solenoid –normally installed in the front of each cylinder head — is used to precisely control the flow of oil into the camshaft actuator.