Can a burnt out headlight be replaced on an odyssey?
Although the Odyssey is fun and easy to use, replacing a burnt-out headlight can be a real pain. This otherwise simple task is complicated by the placement of the Odyssey’s air intake system, which cramps any accessible work space around the driver’s side headlight.
How do you replace a headlight in a van?
Open the van’s hood and locate the intake duct from the air box. Remove the plastic pop rivets that secure the duct to the frame by pushing down on the center of the rivet and then pulling the entire rivet out. Pull the duct upward and away from the headlight assembly. Replace the burnt-out headlight bulbs as normal.
How do you remove a bulb from a headlight?
Squeeze the harness connector and pull it away from the bulb. Pull the rubber dust boot away from the headlight bulb. Squeeze the spring retaining clip together and pivot away from the bulb. Pull the bulb out of the headlight assembly. Insert a new bulb into the headlight assembly and close the retaining clip.
How do you put rubber dust boot on headlight?
Pull the rubber dust boot away from the headlight bulb. Squeeze the spring retaining clip together and pivot away from the bulb. Pull the bulb out of the headlight assembly. Insert a new bulb into the headlight assembly and close the retaining clip. Place the rubber dust boot onto the end of the bulb.
Although the Odyssey is fun and easy to use, replacing a burnt-out headlight can be a real pain. This otherwise simple task is complicated by the placement of the Odyssey’s air intake system, which cramps any accessible work space around the driver’s side headlight.
Open the van’s hood and locate the intake duct from the air box. Remove the plastic pop rivets that secure the duct to the frame by pushing down on the center of the rivet and then pulling the entire rivet out. Pull the duct upward and away from the headlight assembly. Replace the burnt-out headlight bulbs as normal.
How do you replace a burnt out headlight?
Pull the duct upward and away from the headlight assembly. Replace the burnt-out headlight bulbs as normal. Push the intake duct back into the engine compartment and into its mounting location. Push the center tip of the pop rivets upward until it pops out of the top of the rivet.
What to do if your headlight bulb is not working?
Place the rubber dust boot onto the end of the bulb. Reconnect the wiring harness to the headlight bulb, pressing it firmly onto the bulb’s prongs. Turn the headlights on and check that the bulb is operating properly. If the bulb is not working, check that the wiring harness connector is seated firmly on the bulb’s prongs.
Pull the duct upward and away from the headlight assembly. Replace the burnt-out headlight bulbs as normal. Push the intake duct back into the engine compartment and into its mounting location. Push the center tip of the pop rivets upward until it pops out of the top of the rivet.