Are there any GMC or Chevy cruise control kits?
The Cruise Control Store is proud to offer Chevrolet, Buick, and GMC cruise control kits. Chevrolet, commonly referred to as Chevy, has been around since 1911, and is known for a number of different models including the Impala, Corvette, Camaro, Tahoe, Silverado, and more. Buick was founded in 1903 and currently sells…
Why does my GMC Sierra 1500 cruise control not work?
Cruise control does not work properly,when descending down a hill,the truck picks up speed,there is no hold back,it just like it free wheels. See all problems of the 2004 GMC Sierra 1500 . Cruise control does not hold back in down hill decent,it just free wheels, set at 45 mph,it will go to 60 or faster until you put on the brakes.
What to do if your Cruise Control is not working?
A diagram of the stoplamp switch. This switch can be found on the steering wheel, although some switches can be found on the dashboard. If only one setting on your cruise control does not work, chances are high that the switch is the problem. Test the switch the same way the brake switch is tested.
How do you turn off cruise control on a Chevy Silverado?
This action signals the cruise control module (or powertrain control module) to monitor the speed sensor and actuate the throttle as necessary. To turn cruise control off, the driver can either select “off” on the switch or close the stoplamp switch on the brake pedal assembly.
Why does my cruise control not work on my Chevy?
After sliding backwards pulling a trailer down a hill (Avoided Jack-knifing BARELY) my cruise stopped working. I checked the tail lights and they were out. Grabbed a few fuses and saw no issues so I was quite worried.
Where is the cruise control switch on a Chevy Silverado?
This switch is located on the brake pedal assembly and allows current to flow to the cruise control module to signal cruise deactivation. To test the switch, use a digital multi-meter set to ohms and read the resistance between terminals “A” and “B.” Resistance should be less than or at 0.3 ohms. Figure 2. A diagram of the stoplamp switch.
Where is the wire for the cruise control?
My truck occasionally is turning over 2 or 3 times and then starting and resets the clock. If the mechanic finds what the problem is I will let everyone know if I don’t get it fixed tonight which is doubtful. The wire is located just to the left of the brake pedal.