Are sway bar links Universal?
Upgrade from the old units to Whiteline sway bar links with superior features that outlast and outperform the original equipment. …
Can you replace just one sway bar link?
Is it necessary to replace both sway bar links if only one is bad? The answer is no, however your mechanic may recommend replacing both sway bar links because both links usually wear at the same rate and if one is bad, the other may go soon too.
Is it safe to drive with broken sway bar link?
If you suspect that a sway bar is broken, you can still drive the car, but you must use caution. It will feel “looser”, particularly when driving at high speeds. It’s very possible that this will cause you to lose control of the car, resulting in a serious accident if you’re not prepared for it.
Can you over tighten sway bar links?
When installing MOOG bolt style sway bar links (also called barrel lock nut), it is important to avoid overtightening the bolt. During installation, make sure that you don’t overtighten the bolt or you could put excess stress on the stud that could cause it to break.
How much should it cost to replace sway bar links?
The average sway bar link replacement cost is usually between $125 to $160 including labor. The links themselves cost between $40 to $110 each, while the labor will set you back anywhere between $50 to $70.
How do you replace a stabilizer link on a sway bar?
To replace the end links, two nuts are removed, one from the strut, and the other from the sway bar. The new link is an Original Grade part from Mevotech.
How do you replace a sway bar bushing?
To replace the sway bar bushings, the sub-frame has to be dropped slightly to access two rear bracket bolts. This is because the sway bar bolts on top of the sub-frame, but is underneath the body, not leaving enough room to back off the bolt. The front bracket bolt can be removed using a ratchet through the wheel well.
What to do if your sway bar is not working?
To diagnose this, disconnecting the two sway bar end links and taking the vehicle for a test drive can narrow the problem down.
How do you remove a sway bar bracket?
This is because the sway bar bolts on top of the sub-frame, but is underneath the body, not leaving enough room to back off the bolt. The front bracket bolt can be removed using a ratchet through the wheel well. The bracket has an arrow on it, possibly indicating the front of the vehicle although the bracket looks symmetrical.