Why is the p0335 crankshaft sensor no signal?
Honda has determined that the P0335 — Crankshaft sensor no signal and P0339 — crankshaft sensor circuit intermittent interruption trouble codes are caused by corrosion in an electrical connector. Do NOT automatically replace the crankshaft sensor.
How often does Honda Accord p0339 CKP set?
In this article the problematic subject vehicle was brought to an Autologic equipped shop by a neighboring repair shop. They were fighting a reoccurring P0339 that would set once on average once per day.
What are the trouble codes on a Honda?
Honda has issued a service bulletin 16-011 to address trouble codes P0335 and P0339 on the Honda vehicles listed below. Honda has determined that the P0335 — Crankshaft sensor no signal and P0339 — crankshaft sensor circuit intermittent interruption trouble codes are caused by corrosion in an electrical connector.
Is there a problem with the Honda Accord p0302?
Jumps a 30kV gap looks blue enough to rule out a secondary issue. Great. MAP sensor voltage looks OK < .90v with the engine hot @ idle. Pretty much rules out a sticking valve or the valves being out of adjustment. Concur, and just about rules out engine pumping problems. That and the good compression test.
What does p0339 stand for on Honda ECM?
If you tried to start your Honda with a weak battery, the ECM will see improper engine rotation patterns from the crankshaft positon sensor and set a P0339, P0302, P0303. P0339: Crankshaft Position (CKP) Sensor Circuit Intermittent Interruption
What causes the p0339 Honda crankshaft position sensor to change?
When the engine is running, the high and low parts of the teeth cause the gap with the sensor to change. The changing gap causes the magnetic field near the sensor to change. The change in the magnetic field cause the voltage from the sensor to change. Need more information on how to fix the P0339 HONDA code?
What causes a faulty crankshaft sensor on a Honda Accord?
P0339 HONDA Possible Causes Faulty crankshaft position sensor Crankshaft position sensor harness is open or shorted Crankshaft position sensor circuit poor electrical connection Signal plate may be damage Starter motor may be faulty Starting system circuit Dead or weak battery
When does the trouble code p0339 set?
If an abnormal amount of pulsing signals from the CKP sensor are detected, a malfunction is detected and a trouble code is stored. P0339 sets if the ECM detects a result of anything other than 58 pulses during intervals between reference pulses for each crank revolution and the condition has been detected at least 30 times.