Why is my Whirlpool not draining and spinning?
If your washer won’t drain or spin, the water level control may be faulty. Open the machine’s control panel and look for a plastic tube attached to the water level valve. If it’s clogged, clear it out with vinegar. If the valve itself is corroded, it may need to be replaced.
Why is my Whirlpool washing machine not draining water?
If your washer’s drain hose is kinked or bent, the washer will not be able to drain properly. The drain hose may also be obstructed by a small article of clothing. Check your drain hose and remove any obstructions, and straighten it if it’s bent. Make sure the hose is placed less than eight feet above the floor.
How do I force my Whirlpool washer to drain?
Find the “Pause/Cancel” button on the control panel. Press this button twice to drain the washer. Press the “Power” button and rotate the cycle selection knob to “Drain and Spin” to remove the remaining water from the load. Check the washer’s discharge hose if the water fails to drain from the washtub.
How do I reset my Whirlpool washer that won’t spin?
Method 1: Unplug it The first way you can reset whirlpool washer top load is by unplugging it for about 2 minutes then plug it back in and wait about 30 seconds before starting the washer again. This performs a hard reset on the machine and it will start over after you reconnect it again.
Why does my washer stop on the spin cycle?
A clogged drain trap can be a common non-mechanical reason for a front-load washer to stop spinning. Lint and small items that have been left in pockets or inadvertently picked up with the laundry may collect in the drain trap.
Where is the coin trap on a Whirlpool top load washer?
Inside the center agitator: If you have a top-loading washer, inspect the center agitator. The cover may be removable, revealing a lint trap inside. At the end of the drainage hose: A small mesh screen may be fitted onto the end of the hose that drains water out of the machine.
Is there a reset button on a Whirlpool washing machine?
Why is my Whirlpool washing machine not spinning?
When the Whirlpool washer won’t spin, the likely culprit is a broken drive belt. The drive belt is located at the bottom of the machine and connected to the pump, responsible for washing water circulation. You can check this belt by looking at it and feeling for any cuts or cracks — if it’s damaged, you’ll need to replace it.
What to do if your Whirlpool washer is not draining?
Disconnect the water supply to the washer. On a front-load washer, remove the rear access panel. For a top-load washer, first secure the lid with tape so that it will not open. Then, lay the washer on its front to access the drain pump underneath the washer. Disconnect the drain pump wire connector.
How tall is the drain hose on a whirlpool washer?
If you are unable to straighten the hose or clear an obstruction, you will need to replace the hose. Also check the height. Whirlpool advises that the height of the drain hose should not exceed 96 inches, as this will cause water to flow back into the tub.