Why is my Radio not turning off with ignition?
Both of these devices stopped working when 13 blew. I pulled the tapped blown fuse and put another 20A fuse in. Everything works and the radio turns off with the ignition now. There is nothing else after market in the car. Very strange. Next is to pull the radio and see if I can see those fused wires coming into car behind the console.
Why is my XM Radio not turning off?
Strange happenings this morning. Last night I put Pano top on. Took a bit to get it to latch. This morning I noticed radio would not turn off with ignition. In addition, I am getting no power to the cigarette lighter, nor to my XM radio receiver that is hardwired into that circuit.
Why does my Mercedes Benz radio not shut off?
In my repairs I have only seen it twice, yet the average Joe can perform this test to verify the operation with an ohm meter if she/he is willing to remove the radio, and opening the radio. Finally got to look at this. Fuse 13 for the cigar lighter is blown. However, this fuse has a Red wire integrated into it with atttached inline fuse.
What to do when your radio won’t shut off?
Check the Cigar Lighter fuse under the hood. It should also fix your radio problem. Check your fuses like others said, but sometimes the volume control/momentary switch shuts close, yet not very common.
Why does my Mercedes Benz have no sound?
Troubleshooting the fiber-optic loop is the next step that you should do if removing the fuses does not solve the no-sound problem. The fiber optic cables are used to transmit the sound signal of your Mercedes-Benz between the different units for better sound quality and faster transfer rates.
What to do if your Mercedes Benz Radio is not working?
For you to do that, you will need to remove the fuses for the CD Changer, COMAND/ NAV / DVD Player / Radio, Audio Gateway AGW, and the Voice Unit if it is equipped with one, for at least 10 minutes. Doing a soft reset for these systems will force the head unit to rest. This normally restores the systems to working order.
Troubleshooting the fiber-optic loop is the next step that you should do if removing the fuses does not solve the no-sound problem. The fiber optic cables are used to transmit the sound signal of your Mercedes-Benz between the different units for better sound quality and faster transfer rates.
How to install a stereo in a Mercedes?
Mercedes Car Radio Stereo Audio Wiring Diagram Autoradio connector wire installation schematic schema esquema de conexiones stecker konektor connecteur cable shema car stereo harness wire speaker pinout connectors power how to install. Mercedes Car radio wiring diagrams. Car radio wire diagram stereo wiring diagram gm radio wiring diagram.
What to do if Mercedes Benz audio gateway is defective?
You need to figure out which component is defective by bypassing each component until you find the problem. The Audio Gateway is the brains of the Mercedes-Benz COMAND system. You will need to have an authorized Mercedes-Benz service technician replace the whole unit if AGW is defective. This entry was posted in Info Articles.
Both of these devices stopped working when 13 blew. I pulled the tapped blown fuse and put another 20A fuse in. Everything works and the radio turns off with the ignition now. There is nothing else after market in the car. Very strange. Next is to pull the radio and see if I can see those fused wires coming into car behind the console.
What causes a Mercedes Benz ignition to not turn?
Mercedes EZS EIS Ignition Switch Problem, Cause, Solution. A problem that Mercedes-Benz owners may face is the key no longer turns in the ignition. This issue is often caused either by a defective key, bad shifter module, a failed Electronic Ignition Switch (EIS) also known as the EIS-EZS or a bad steering lock module (ESL).
In my repairs I have only seen it twice, yet the average Joe can perform this test to verify the operation with an ohm meter if she/he is willing to remove the radio, and opening the radio. Finally got to look at this. Fuse 13 for the cigar lighter is blown. However, this fuse has a Red wire integrated into it with atttached inline fuse.
Why is my Mercedes EZs EIS ignition not working?
The only issue here is that if you can’t turn on the ignition, you can’t power on the OBD2 port and the iCarsoft MB II scanner. If the ignition turns on intermittently, consider yourself lucky and scan for codes. Hopefully, there are fault codes that will point you to the problem. Diagnosing Mercedes ignition problems isn’t a simple DIY job.
What to do if your Nav screen is not turning off?
Never actually tried that on any customer’s cars, if they stick we just replace the latch. The “module” is actually the “Driver’s Door Module”. The drivers door module is basically just the switch panel with the window and door locks in it. That part needs to be programmed if it’s replaced.
Why does my radio not switch off with ignition?
As above, switches of on key removal. Ours switches itself off after some 20-30 minutes or so. It will be a CANBUS type problem. In the good old days there would be a 12v Feed and a switched 12v Feed. The 12v feed would keep the memory, and the switched feed would turn the radio on/off with the Key.
What should I do if my car radio won’t turn off?
Check your owner’s manual. Your radio should have a means to turn it off while the car is running. Some people, including me, don’t like having the radio on while they drive. I use the radio rather sparingly–there isn’t much on the radio that appeals to me.
Why are the radio and dash lights not turning off?
Here is an update: now a message comes up that the drivers door is open but pushing the menu button turns it off, the drivers window doesn’t work. The radio and dash lights turn off most of the time. Any ideas? Ron 4 people found this helpful.
What happens when ignition is turned off on a Buick LaCrosse?
Buick LaCrosse Questions – radio and dash lights will not turn off when ignition is turned off. – CarGurus radio and dash lights will not turn off when ignition is turned off.