Why is my Mazda 323 hard to start?
Sounds like that is exactly the problem. If the distributor cap cracks, it can allow either moisture to get in or sparks to come out. Both cause problems. If moisture gets in, it will cause the car to be difficult to start until the cap dries. If spark gets out, it will cause the engine to sputter.
What to do when your Mazda remote stops working?
When it stops working, the first thing you want to do is fix it. Before you head off to buy a new remote, there are a few other things that you can do to try and get it to work again. Simultaneously hold the open and the lock button down for 60 seconds. This should reset the system. If it worked, the interior car lights will go on and off.
What should I do if my car won’t start?
With the key in the “start” position, if the starter motor is getting power but it doesn’t work, the starter is condemned and replaced. On the other hand, with the key in the “start” position, if there is no power to the starter, then the circuit is traced until the fault in the circuit is found.
Why is my Mazda door FOB not working?
The key fob for your Mazda has a built-in chip that’s programmed so your security system will both recognize and accept it – allowing you to open your doors. You obviously use your keyless remote to open your Mazda door because it is convenient. When it stops working, the first thing you want to do is fix it.
What to do if your Mazda3 won’t start?
One way to do this is to start your car and let the engine run for a while to recharge the battery. One thing to know: if the battery is over 4-5 years old, it may be completely dead, so it will not recharge and the car will not restart after you turn it off. In this case, you may need a new battery.
Why does my car not start if the battery is OK?
If the battery is OK, but the starter still won’t start, there could be a number of possible reasons. Here are a few: The ignition switch could be faulty – this is a common problem.
Where is the ignition switch on a Mazda 3?
An ignition switch is an electrical switch installed on the rear of the ignition lock mechanism. If shaking the key in the ignition switch helps to start the car, you should check the ignition switch first. The starter solenoid control wire may have a bad connection.
Why does my car have a bad motor?
Very often this can be due to a low battery or a bad connection to the battery terminals. Sometimes a battery cable can corrode inside and cause the same problem. In some cases, a bad connection between the negative battery cable and the motor (bad ground) can cause the same symptoms.
Sounds like that is exactly the problem. If the distributor cap cracks, it can allow either moisture to get in or sparks to come out. Both cause problems. If moisture gets in, it will cause the car to be difficult to start until the cap dries. If spark gets out, it will cause the engine to sputter.
What are the rules for a Mazda 323 GTX?
“The rules are really tight in Group A,” Millen said at the time, explaining that about the only changes allowed were pistons and cam, polishing of heads, upgraded turbocharger, and installation of larger brakes, radiator and oil cooler. Triggering this bit of nostalgia is Mazda’s corporate centennial.
How much does it cost to replace engine cap on Mazda 323?
If moisture gets in, it will cause the car to be difficult to start until the cap dries. If spark gets out, it will cause the engine to sputter. The cap only costs maybe $20 at your local part store and is very easy to replace. You should also replace the rotor at the same time as the cap.
Do you need a service history on a Mazda 323?
A service history is obviously a necessity on such a new car. (Estimated prices, based on a 323 1.5) The 323 has been designed for easier servicing and lower repair costs than previous generations, which had gained a reputation as being costly to put right in the rare instances that something did let go.
What kind of engine does the Mazda 323 have?
5dr hatch, 1.3, 1.5, 1.6, 1.8, 2.0 petrol 2.0 turbo diesel [LXi, GSE, GXi, GSi, SE, Di, Sport] Mazda certainly had a few rival motor manufacturers scratching their heads in confusion when they launched the 323F in 1989. Ford Escort rivals weren’t supposed to have a swooping coupe-like roofline or sporty pop up headlamps.
What’s the boot space on a Mazda 323?
The sliding seats are less comfortable than the fixed ones and the extra height added by the mechanism reduces headroom for rear seat dwellers, already at a premium. In any case, the standard boot space is pretty reasonable at 354 litres and is extendable by split folding rear seats.
A service history is obviously a necessity on such a new car. (Estimated prices, based on a 323 1.5) The 323 has been designed for easier servicing and lower repair costs than previous generations, which had gained a reputation as being costly to put right in the rare instances that something did let go.
5dr hatch, 1.3, 1.5, 1.6, 1.8, 2.0 petrol 2.0 turbo diesel [LXi, GSE, GXi, GSi, SE, Di, Sport] Mazda certainly had a few rival motor manufacturers scratching their heads in confusion when they launched the 323F in 1989. Ford Escort rivals weren’t supposed to have a swooping coupe-like roofline or sporty pop up headlamps.
The sliding seats are less comfortable than the fixed ones and the extra height added by the mechanism reduces headroom for rear seat dwellers, already at a premium. In any case, the standard boot space is pretty reasonable at 354 litres and is extendable by split folding rear seats.
When did the Mazda 323 series come out?
The Mazda 3 came along in 2004 and spelled the end of the long-running 323 series. Under the skin, 40% of the 323’s parts have been sourced either from the old model or the current 626. Since both of these cars were originally engineered for practical rather than performance purposes, that’s largely what you get.
If moisture gets in, it will cause the car to be difficult to start until the cap dries. If spark gets out, it will cause the engine to sputter. The cap only costs maybe $20 at your local part store and is very easy to replace. You should also replace the rotor at the same time as the cap.
When did the Mazda 323 first come out?
While the 323 was sold as a regular car for its class several attempts were made to push it up into the luxury segment. Between 1994 and 1998 it even came with the option of a V6 engine. That expensive Mazda 323 wasn’t a success and the company crept quietly back into its usual market area.
Is the Mazda 323 considered a family car?
The 323 is often sadly overlooked by many tuners and dismissed as a family car. The 4×4 Turbo 323 really shows what can be achieved with this platform and gives inspiration to all those 323 owners looking for more power.
What are Stage 3 mods for Mazda 323?
Stage 3 mods: Engine balancing, forced induction (turbo/supercharger), Internal engine upgrades (pistons/head/valves), competition cam. Your targets when modding your car should be a flat and wide torque curve. You want to avoid sending all the power to be at the top end of the rev range unless you are creating a motor sport car.
What are the symptoms of a Mazda transmission problem?
Common symptoms of Mazda transmission problems: 1 Harsh shifting 2 Transmission won’t engage. 3 Shifts are delayed 4 Engine revving at high RPM 5 Burning smell 6 Check engine light comes. 7 Mazda won’t move when in Drive or Reverse. 8 Stuck in limp mode 9 Won’t shift gears
Are there any transmission problems with the Mazda 626?
Mazda vehicles were notorious for automatic transmission problems in the early 2000s, especially the 626, Millenia, and MPV models. From 2005 to 2020, Mazda automatic transmissions in Mazda 3, 5, 6, CX-7, CX-9 have been very reliable with very few transmission issues. That doesn’t mean that Mazda transmissions never fail.
What kind of transmission does a Mazda 3 have?
Today we see many Mazda vehicles, including Mazda 3, Mazda 6, Mazda 5, CX-5, CX-9, CX-3, Miata, CX-30, and the Mazda SkyActiv 6-speed automatic transmission, that goes over 100,000 or even 150,000 with no transmission issues. In this article, we covered problems that affect several Mazda transmissions.
Mazda vehicles were notorious for automatic transmission problems in the early 2000s, especially the 626, Millenia, and MPV models. From 2005 to 2020, Mazda automatic transmissions in Mazda 3, 5, 6, CX-7, CX-9 have been very reliable with very few transmission issues. That doesn’t mean that Mazda transmissions never fail.
Common symptoms of Mazda transmission problems: 1 Harsh shifting 2 Transmission won’t engage. 3 Shifts are delayed 4 Engine revving at high RPM 5 Burning smell 6 Check engine light comes. 7 Mazda won’t move when in Drive or Reverse. 8 Stuck in limp mode 9 Won’t shift gears
Today we see many Mazda vehicles, including Mazda 3, Mazda 6, Mazda 5, CX-5, CX-9, CX-3, Miata, CX-30, and the Mazda SkyActiv 6-speed automatic transmission, that goes over 100,000 or even 150,000 with no transmission issues. In this article, we covered problems that affect several Mazda transmissions.
Where is the fault code on a Mazda?
If the transmission fluid is correct, next read the fault codes stored in the Transmission Control Unit (TCU) via the diagnostic port under the dashboard with a Mazda OBD-II scanner.
The 323 is often sadly overlooked by many tuners and dismissed as a family car. The 4×4 Turbo 323 really shows what can be achieved with this platform and gives inspiration to all those 323 owners looking for more power.
Is the Mazda 323 a 4×4 turbo car?
The 323 is often sadly overlooked by many tuners and dismissed as a family car. The 4×4 Turbo 323 really shows what can be achieved with this platform and gives inspiration to all those 323 owners looking for more power. The car was a rally legend in 4×4 form showing how capable the chassis is.
What’s the best tuning for a Mazda 323?
Our aim in 323 engine tuning should be to increase peak power and Torque at the top end. 323 make good sleepers if you debadge them and fit the most powerful engine you can find! Many look for the 4×4 Turbo engine as a suitable candidate although some of the newer 3 engines make excellent candidates for a swap.
Why does my car stall when I come to a stop?
With ignition coil failure, your vehicle will have irregular sparks emitting to the plugs to keep it running. This will result in stalling. When you bring your vehicle to a stop, it may just shut off totally, thus leaving you needing to restart it.
How to fix stalling after replacing the engine?
Start by making sure that your vehicle is parked on level ground with the parking brake set. The engine should be cold. All power accessories should be off, including the heat, air conditioning, audio system and interior lights.
How to remove front and rear bumper for Mazda 323F?
-attach the fender liner to the side and Unscrew the screws that attach the bumper to the wings. -in models where it is technically possible, we remove the direction indicators (Unscrew one screw on each side at the edges of the headlights and take out the forward pointers). In the resulting niche take out the caps.
What kind of transmission does a Mazda 323 GTX have?
Once again, transmissions are the primary sticking point, with most available replacements already gobbled up by rally teams or collectors in the decades between now the 323 GTX’s heyday.
Why does my Mazda 3 Takumi have GPS problems?
It is struggling to find GPS but even when it does it seems to be the wrong location. Same problem for me – Mazda 3 Takumi. It keeps placing me on a wrong position on the map.Sometimes it gets back while driving but after going off a main road or after shutting down the car it is all messed up again.
What does the PCM do on a Mazda?
by Ashley Hay. The powertrain control module (PCM), or engine control unit (ECU), is a circuit board computer that stores information pertaining to different areas of your Mazda’s engine. If your Mazda’s check engine light or another malfunction indicator light illuminates, it is because of a signal the PCM received.
Where is the number on a Mazda 323 protege?
My 2002 Mazda 323 protege 1.8 is located on a tab sticking out of the block on the front of the block just below the coolant hose. It is usually a bit rusty so i sanded it with a bit of fine sandpaper then i rubbed white chalk on it so the chalk embedded into the number. 1 people found this helpful.
Where to find the engine number on a Mazda 323?
The eighth digit of your VIN number will identify which engine your car has. the VIN number is located on your driver’s side dash and it can be viewed through the windshield from outside the vehicle. It will also be on your registration card and title.
Why are the lights not working on my Mazda 3?
A-E and A-B-E-K is continuity check terminal of headlight switch. If switch isn’t making proper contact, TNS relay won’t triggers. You can’t replace only TNS relay unfortunately, so you need to source entire PJB relay/fuse unit. Have you been able to solve this issue yet? I have the same problem and I noticed that I i tap the PJB they come back on.
Can you change fuse box on Mazda 3?
A service man at The Mazda dealership in Lexington, ky, told me they won’t touch the 2nd hand PJB, because it may or may not be faulty. So basically their take on changing fuse boxes like a pjb is you must first buy one from them ($900).