Why is my liftgate not lifting the load?
Platform will lift rated loads, but drifts down. Platform will not lower. Platform lowers extremely slowly. Bent latch pin. Hydraulic oil leaks from cylinder rod end. Platform will not raise to full raised position. Broken roller wheel.
What to do when liftgate platform goes out of sync?
Power the liftgate platform up to the top before locking the platform. Hold the button at the top for 5-10 seconds to relevel the platform. Sometimes if the platform goes out of sync it may need to be relevelled at the top before it goes into the locks properly. 6.1) Platform leaks down.
Where can I find the liftgate repair manual?
Standard Series and Deluxe Series (AST and ATU) – This is a link to the Standard Series and Deluxe Series liftgate repair manual. This is a PDF file and you need to download Adobe Acrobat Reader if you do not already have this on your system. Platform will not raise, liftgate motor does run. Platform will not raise, motor does NOT run.
Is it normal for an Anthony liftgate to break?
Anthony Liftgates don’t break often, but even the most rugged parts don’t last forever. Damage or normal wear and tear can interfere with normal liftgate operation. We’ve prepared this section to help guide you step-by-step through the most common troubleshooting procedures for liftgate repair.
Why does the lift gate close on its own?
If that does not help, observe while the lift gate goes up to see if there is any hesitation or binding as the door goes up as misalignment may also be an issue. Your problem is probably that the lift gate sensor “senses” a non-existent obstruction.
How do you change the position of the liftgate?
While holding the liftgate in position, press and hold the liftgate switch located on the liftgate for approximately 5 seconds or until 3 beeps are heard. The liftgate will open to the selected position setting. To change the position of the liftgate, repeat steps 1-3 for setting the position of the liftgate.
Why is the lock valve on my liftgate not working?
Lock valve has power and lowering valve has power. If in your test for lowering, the gate raises fine but just will notlower, it most likely is a bad lower valve and coil. Feel the valve when activating switch. You should feel a pulse on the valve and hear it click. If you can’t feel the valve activate or hear a clicking, change the valve and coil.
How do I get the lift gate to close on my head?
I get a slight bump and then it goes back up. Open the lift gate from the inside switch, take the key fob out of your pocket and leave it in the car. You will find when your back there, the lift gate will no longer close on your head. Bottom line, don’t be dancing around close to the bumper with the key fob in your pocket.