Why is my Kia thermostat still in place?
The thermostat may be held in place because of vacuum, and the pliers give you the necessary leverage to twist it a bit to pull it loose. Replace the old unit with your new thermostat and gasket. Once installation is complete, put all of the engine parts you’ve removed back in place by reversing the steps above.
Where is the thermostat on a Kia Rio?
Use the pliers to remove the clamp from the upper radiator hose connecting to the thermostat cover, located on the passenger side of the Kia Rio engine bay. Cover the opening of the hose to prevent contaminants from entering your cooling lines. Remove the bolt from the thermostat cover, then set the cover aside.
How do you change the thermostat on a Kia Sedona?
Make sure to use a drain pan to catch all of the antifreeze as it drains from the radiator. Remove the engine cover. On the Kia Sedona, it’s the large, gray composite piece that sits right in the top center of the motor. Use the appropriate screwdriver (such as a Phillips) to remove the six screws that hold the cover. Take off the air intake.
Where does the thermostat sit in a car?
The car thermostat sits between the engine and the radiator. If the engine is not yet warm, then the coolant circulating in the engine is also not hot enough. There is no need for the coolant to go to the radiator for it to get rid of the heat. This is the main responsibility of the thermostat.
Use the pliers to remove the clamp from the upper radiator hose connecting to the thermostat cover, located on the passenger side of the Kia Rio engine bay. Cover the opening of the hose to prevent contaminants from entering your cooling lines. Remove the bolt from the thermostat cover, then set the cover aside.
The car thermostat sits between the engine and the radiator. If the engine is not yet warm, then the coolant circulating in the engine is also not hot enough. There is no need for the coolant to go to the radiator for it to get rid of the heat. This is the main responsibility of the thermostat.
The thermostat may be held in place because of vacuum, and the pliers give you the necessary leverage to twist it a bit to pull it loose. Replace the old unit with your new thermostat and gasket. Once installation is complete, put all of the engine parts you’ve removed back in place by reversing the steps above.
Make sure to use a drain pan to catch all of the antifreeze as it drains from the radiator. Remove the engine cover. On the Kia Sedona, it’s the large, gray composite piece that sits right in the top center of the motor. Use the appropriate screwdriver (such as a Phillips) to remove the six screws that hold the cover. Take off the air intake.