Why is my coolant gauge high?
If the temperature gauge reads high, it could mean your engine is overheating. Another reason your reading might be high is you could be losing coolant. A small leak or evaporation may cause your radiator to slowly lose coolant. A third reason your temperature gauge reads high could be because the thermostat is broken.
Why is my temperature gauge not going up?
The most common cause of faulty temperature readings is a broken coolant temperature sensor (CTS). The part, which is normally located near a vehicle’s thermostat near the base of the radiator (consult your owner’s manual or repair guide) can get gunked up and fail. Disconnect the temperature sensor’s wiring connector.
How do you know if your coolant sensor is bad?
What Signs May Signal Your Coolant Temperature Sensor May Be Failing?
- Poor Fuel Economy.
- Irregular Temperature Readings.
- Black Smoke from Your Exhaust.
- Your Engine is Overheating.
- Your Check Engine Light is On.
How does a coolant temp sensor work on a fan?
Coolant Temp Sensor – LH head. I have used a t-stat housing mounted fan switch with excellent results. Sounds like you hooked up a gauge to a temperature switch. That’s a problem right there. A gauge won’t run off a temperature switch. Also that temp switch supplies the switchable ground connection to the fan relay.
Where is the temp Guage and electic fan sending unit?
Installed the temp sender for gauge where the original one was installed on the driver’s side head. I also have A/C, so I installed a diode in the power lead to the fans to keep the current from “back flowing” to the relay when the A/C is turned on.
Is there a way to test a radiator fan?
You can test the electrical radiator fans by taking a wire from the car battery, unplug the radiator fan connector, and put 12v+ and ground into the connector. This is the fastest and easiest way to test your radiator fans. Because the radiator fan is often drawing so much power, there is often a relay that is powering the coolant fan.
Where is the relay on a radiator fan?
The fan relay is often located in the engine bay’s fuse box, but the best way is to check your repair manual to find where it is located. Testing a 4 pin relay is often very straightforward. Remove the relay and give 12 volts to pin 30 and 85. Ground pin 86 and check if there is voltage coming out from pin 87.