Why is my Caterpillar C13 engine not starting?
Check Caterpillar Electronic Technician (ET) for any associated codes that are listed in Table 1. Troubleshoot any active codes before continuing with this procedure. Note: If the engine will not start and Cat ET will not communicate with the ECM, the problem is most likely with the electrical power supply to the ECM.
What to do if your C15 cat wont start?
Put a wrench on each one and make sure they are tight. Vampire and silver dollar Thank this. Sounds like you may have a leak somewhere between the tanks and the lift pump (suction side). Could be as simple as a loose fuel line fitting. Put a wrench on each one and make sure they are tight.
What to do if your engine wont start?
Note: If the engine will not start and Cat ET will not communicate with the ECM, the problem is most likely with the electrical power supply to the ECM. Refer to Troubleshooting, “Electrical Power Supply – Test”. Note: The procedures have been listed in order of probability.
What to do if your cat wont start?
No point climbing around under the truck if its at a filter housing or the lift pump. silver dollar and Vampire Thank this. If you see any dirt on the lines that should be where the fuel is leaking from. Good luck. silver dollar Thanks this. Sounds like it could be your check valve getting weak. silver dollar Thanks this.
What should I do when Cranking my engine?
Check the fuel tank for debris or foreign objects which may block the fuel supply. D. Check the filtered fuel pressure while the engine is being cranked. Refer to Systems Operation/Testing and Adjusting, “Fuel System” for the test procedure and for the correct pressure values.
What does it mean when engine cranks are abnormal?
Upon initial cranking, the status for engine speed may indicate that the engine speed signal is abnormal. This message will be replaced with an engine speed once the ECM is able to calculate a speed from the signal. Result: The timing sensor is operating properly. Proceed to Test Step 8.
Why does my cat engine won’t start?
Cat Engine Won’t Start Troubleshooting. Diesel Engine Crank No Start. – YouTube Cat Engine Won’t Start Troubleshooting. Diesel Engine Crank No Start. If playback doesn’t begin shortly, try restarting your device.
Why does my car not start when I crank the engine?
If the engine doesn’t crank, or makes an unusual noise when cranking, you may have a starting system problem. The car’s security system may have made an error that disabled the fuel or ignition system, or the chip in the key may have failed.
What to do if your cat engine won’t start?
Diesel Engine Crank No Start. – YouTube Cat Engine Won’t Start Troubleshooting. Diesel Engine Crank No Start. If playback doesn’t begin shortly, try restarting your device. Videos you watch may be added to the TV’s watch history and influence TV recommendations. To avoid this, cancel and sign in to YouTube on your computer.
What is the cat code for a C13 engine?
J1939 Code and Description CDL Code and Description CAT C13, C15, and C18 Tier 4 Final Engine Fault Codes 108-21 3528 -21 Barometric Pressure : Calibration Required Atmospheric Pressure Sensor : Calibration Required 109-3 2302-3 Engine Coolant Pressure : Voltage Above Normal Engine Coolant Pump Outlet Pressure Sensor : Voltage Above Normal
How to find the code for a Caterpillar engine?
Use the Caterpillar Electronic Technician (ET) in order to determine the codes that are active or logged. Then refer to the appropriate troubleshooting procedure for more information. Troubleshooting, “Sensor Signal (Analog, Active) – Test” Troubleshooting, “Sensor Signal (Analog, Active) – Test”
Why does my car engine not start up?
Of course there are numerous other reasons why a particular design of engine may not start. Some may have to do with the engine itself, others may have to due with other systems that the engine interacts with, such as; electrical starters and safety interlock systems that will vary by product design.