Why is my AC popping fuses?
The most logical cause of your air conditioner tripping a breaker or blowing a fuse when it comes on stems from a problem with the electrical connection, the power supply, or the circuit that powers the system. Breakers and fuses are designed to trip or blow when too much voltage is sent through the line.
What makes AC relay go bad?
Possible causes are low refrigerant, a faulty pressure switch, a faulty control switch or a faulty computer. If power and ground are found here, move to the next step. With the engine running, and the A/C controls in the max cooling positions, test for power at the compressor clutch electrical connector.
How is the compressor clutch relay turned on and off?
In some vehicles the compressor clutch relay is turned on and off by the low pressure switch and the evaporator temperature sensor. In a computer controlled system, the compressor clutch relay is grounded by the computer. If the fuse is good, disconnect the electrical connector from the compressor clutch coil.
Why is my central AC not turning on?
The issue is usually a lack of power. Check your breaker box for a blown breaker or tripped fuse. You may be able to fix this AC issue with the flip of a switch. If that doesn’t do the trick, check the wiring in your thermostat. A loose or frayed wire could also prevent your unit from turning on.
What to do if your air conditioner clutch does not engage?
If the clutch doesn’t engage, the air conditioning compressor can’t pump refrigerant. So start your diagnosis by determining if the compressor clutch works. Turn the air conditioning controls to MAX AC and start the engine. Then look at the front of the compressor clutch.
Where is the emergency shut off switch on my AC unit?
Many outdoor AC units have a shut-off switch. These switches are typically located near the unit and are within a metal box mounted to the exterior of your home. They are sometimes labeled as an emergency shut-off. If you recently had work done on your air conditioner, it’s possible the workman forgot to flip the switch back to the ON position.