Why does the Check Engine light go on on a Harley Davidson?
The check engine light goes on in your Harley Davidson Softail to tell you something is wrong with the motorcycle. If you’re aware of why it’s on and you want it off, this article will help you achieve that.
How to reset check engine light on Harley Davidson Softail?
Turn the ignition switch, which is located in the center of your gas tank, to the OFF position and then turn the Run/Stop switch, which is located on the right side of your handlebar, to the RUN position. Figure 2. Ignition on the tank and Run/Stop on right grip. Press the odometer’s reset button and keep it pressed.
What does the Check Engine light on a Softail mean?
After reading the code, which will tell you exactly what you need to fix or replace, you will be left with an activated check engine light, which can get annoying to look at. This guide will show you how you can check the code and turn off the engine check light on your Harley Davidson Softail.
What happens when the crank sensor on a Harley goes bad?
In newer models, the crank position sensor is designed in such a way that it allows you to reach your destination even after it goes bad. Usually, the symptoms of a bad crank position sensor on Harley Davidson are quite easy to notice. For example, you experience slight hesitation with the engine or reduced mileage, etc.
How to reset the Check Engine light on a Harley Davidson?
Run/Off switch. In this instance, just as any other time you work on your motorcycle, make sure your motorcycle is on a level surface and firmly on the kickstand. With the engine switch on the off position and the run/stop switch in the run position, push the odometer trip reset button and hold.
Why does my check engine light keep coming on?
A check engine light can appear for a variety of issues, and rarely is it serious. It is annoying and, at a bare minimum, every rider should be aware of the process to clear the check engine light and be able to retrieve the code to find out what it means.
In newer models, the crank position sensor is designed in such a way that it allows you to reach your destination even after it goes bad. Usually, the symptoms of a bad crank position sensor on Harley Davidson are quite easy to notice. For example, you experience slight hesitation with the engine or reduced mileage, etc.
Can you reset the cel code on a Harley Davidson?
You may think you need an expensive code scanner or computer to check and reset CEL codes on your Harley, but the Motor Company designed a diagnostic mode into the computer. All you need are your ignition keys and a finger, and a pen to write down the stored codes before resetting.
How do you reset the Check Engine light?
To do that, press and hold the odometer reset button for longer than five seconds until the word “clear” is displayed. Once you see the word “clear,” release the reset button. Repeat these steps as you cycle through the codes. Or, if you don’t want to clear the code, click the button until the display reads “END,” meaning the end of the codes.
When do you get a check engine light on a Harley Davidson?
If you own and ride Harley Davidson motorcycles, you may get a check engine light from time to time. It is inevitable. A check engine light can appear for a variety of issues, and rarely is it serious.
To do that, press and hold the odometer reset button for longer than five seconds until the word “clear” is displayed. Once you see the word “clear,” release the reset button. Repeat these steps as you cycle through the codes. Or, if you don’t want to clear the code, click the button until the display reads “END,” meaning the end of the codes.
What causes a Harley Davidson headlamp to burn out?
When the circuits get damaged due to excessive heat, the charging system gives such misleading info about the battery. The battery receives a very high amount of voltage as the regulator is at an inactive state, which results in tail lamps, headlamps, and other side lamps to burn out.