Why does my Transformer keep blowing fuses?
An overcurrent caused by a fault in the transformer or customer circuit will cause the fuse to melt, disconnecting the transformer from the line. It can also be opened manually by utility linemen standing on the ground and using a long insulating stick called a “hot stick”.
Where are the fuses on a Pontiac G5?
Fuse box diagram (fuse layout), location and assignment of fuses and relays Chevrolet Cobalt and Pontiac G5 (2005, 2006, 2007, 2008, 2009, 2010). The wiring circuits in your vehicle are protected from short circuits by a combination of fuses, circuit breakers, and fusible thermal links.
What causes the fuse to fail when I turn the key to the start?
If the WHITE wire coming off terminal “S” is shorted anywhere between the ignition switch and the clutch/brake switch and the attachment clutch and solenoid it will cause the fuse to open/fail or if “clutch/brake switch or “attachment switch is shorted it will cause the fuse to fail/open whenever the key is turned to the start position.
Where are the fuse blocks in a car?
There are two fuse blocks in your vehicle: the floor console fuse block and the engine compartment fuse block. Before replacing a fuse check that the key has been removed from the ignition and that all the services are switched off and/or disengaged. Do not repair fuses and never replace a blown fuse with one that has a higher amp rating.
Why does my Alt fuse keep blowing out?
I covered the bare metal under it with rubber to ensure that I wouldn’t ground, then screwed a nut and washer ON TOP of the wire, instead of the normal setup which is nut, wire, nut+washer (broken post).
When did the Pontiac G5 fuse box come out?
The Pontiac G5 was produced from 2007 to 2010. In this article, you will find fuse box diagrams of Pontiac G5 2007, 2008, 2009 and 2010, get information about the location of the fuse panels inside the car, and learn about the assignment of each fuse (fuse layout) and relay.
Why does my car keep blowing the fuse?
Blowing Fuses, Car Won’t Start: I Keep Blowing the 20amp Start/… I keep blowing the 20amp Start/Fuel fuse and the car won’t start. I’ve replaced it before, and the car will start and run for a week or two, then blow the fuse again. I replace it again and it may work for a few days before blowing again.
There are two fuse blocks in your vehicle: the floor console fuse block and the engine compartment fuse block. Before replacing a fuse check that the key has been removed from the ignition and that all the services are switched off and/or disengaged. Do not repair fuses and never replace a blown fuse with one that has a higher amp rating.
Where are the fuses located in a Chevy Cobalt?
The floor console fuse block is located on the passenger side of the floor console behind the forward panel. The engine compartment fuse block is located on the driver side of the vehicle. WARNING: Terminal and harness assignments for individual connectors will vary depending on vehicle equipment level, model, and market.