Why does my Suzuki GSXR have a Fi warning?
Originally when the full exhaust Yosh RS-3 was installed all was done was the black/brown wire from the ECU input will prevent that “Fi” warning message from appearing in your instrument panel. That was the only wire cut, that’s it.
What is the F1 code on a Suzuki GSXR 1000?
Click to expand… This is weird, after riding my 2002 GSXR-1000 over 19,000 miles I get the F1 code C46. I follow the directions according to the link which the white connection was still plugged up to the Servo and splice the other two wires B/R & R/B. Code is gone which I tested this after for over 1 hour.
Where is the dealer mode switch on a Suzuki GSXR?
Location of dealer mode switch and how to get the codes. The dealer mode connector is under the tail cowling on the left side of the bike, near the regulator/rectifier. It will have only two wires going to it.
What is the c00 code on a 2005 GSXR1000?
On 2005 GSXR1000 when I install the jumper I get the C00 code. How do I get rid of the F1 and light if nothing is wrong?Looked through everything listed and I did not see anything about it.
What is the CKP code on a GSXR?
TO sensor, wiring/coupler connection. CKP sensor (pick-up coil) signal is produced but signal from ignition coil is not produced continuous two times. In this case, the code c24 or C25 or C26 or c27 is indicated.
Originally when the full exhaust Yosh RS-3 was installed all was done was the black/brown wire from the ECU input will prevent that “Fi” warning message from appearing in your instrument panel. That was the only wire cut, that’s it.
Click to expand… This is weird, after riding my 2002 GSXR-1000 over 19,000 miles I get the F1 code C46. I follow the directions according to the link which the white connection was still plugged up to the Servo and splice the other two wires B/R & R/B. Code is gone which I tested this after for over 1 hour.
What is the fault code for the GSXR ECU?
TP sensor, wiring/coupler connection. The sensor voltage should be the following. (0.15 V < or = sensor voltage < 4.85 V) Without the above range, c15 is indicated. ECT sensor, wiring/coupler connection. The sensor voltage should be the following. (0.15 V < or = sensor voltage < 4.85 V) Without the above range, c21 is indicated.
Location of dealer mode switch and how to get the codes. The dealer mode connector is under the tail cowling on the left side of the bike, near the regulator/rectifier. It will have only two wires going to it.
On 2005 GSXR1000 when I install the jumper I get the C00 code. How do I get rid of the F1 and light if nothing is wrong?Looked through everything listed and I did not see anything about it.