Why does my Nissan Pathfinder rev up at idle?
Got the same issue with my pathfinder too. I unplugged throttle position sensor (TPS/brown plug) and rpm gets worth and it jumps up and down between 1000 to 2000 at idle when car is parked.
Why does my Pathfinder surge at 1500 rpm?
Well guys i have a 2001 pathfinder 4×4 93,xxx miles and when its in park and your rev it inbetween 1500-2000 RPM the truck surges up and dow between 1500-2000 RPM basicaly like its hitting a rev limiter/fuel cut but if i rev it higher it has no problem? only dose it in park or neutral and when in drive truck drives fine….
What’s the idle RPM on a Nissan club?
My engine would rev between 1000 and 2000 (start at 2000, drop down to 1000, and rev up again, repeat) if in park or neutral. I heard this will happen after the clean. Engine stay at 1000 RPM in drive, with brake pedal pressed.
What is the idle relearn procedure for a Nissan?
Battery voltage must be more than 12.9 V engine running at idle Electric load switches OFF. That means no A/C, headlamp, rear window defogger If you have daytime running lights (DRL) do this procedure to shut them off: BEFORE starting the engine: Apply the parking brake, or set the lighting switch to the 1st position.
Well guys i have a 2001 pathfinder 4×4 93,xxx miles and when its in park and your rev it inbetween 1500-2000 RPM the truck surges up and dow between 1500-2000 RPM basicaly like its hitting a rev limiter/fuel cut but if i rev it higher it has no problem? only dose it in park or neutral and when in drive truck drives fine….
Got the same issue with my pathfinder too. I unplugged throttle position sensor (TPS/brown plug) and rpm gets worth and it jumps up and down between 1000 to 2000 at idle when car is parked.
What’s the RPM on a Nissan Pathfinder QX4?
A forum for the legendary Nissan Pathfinder and Infiniti QX4. 1500-2000 RPM Surge??? HELP
What’s the idle air volume learning procedure for Nissan Maxima?
Check that all items listed under the topic PREPARATION (previously mentioned) are in good order. Turn ignition switch “OFF” and wait at least 10 seconds. Start the engine and let it idle for at least 30 seconds. Disconnect throttle position sensor harness connector (brown), then reconnect it within 5 seconds. Wait 20 seconds.