Why does my Jeep Wrangler shudder under acceleration?
The recommended U-joint for Wranglers are the Spicer 5-760x. A bad driveshaft can also cause weird vibrations under acceleration. If the vibration is only noticeable when you apply the gas, is a good indicator that the problem lays in your drivetrain. Car shudders upon acceleration. …
What causes a Jeep Wrangler to vibrate at 60 mph?
This article will cover most of the possible causes of vibrations and what you need to determine to properly diagnose each. The most common cause for Jeep Wranglers to vibrate are improperly balanced tires. Other causes can be any of the following:
What kind of drivetrain does a jeep TJ have?
Here’s a mini-spec list of the axles, transfer cases, engines, and transmissions that came stock in all TJ models and years. If you need to identify your axles, all the info you need is right there. The easiest way to see what kind of rear axle you have is the type of fill plug in it.
The recommended U-joint for Wranglers are the Spicer 5-760x. A bad driveshaft can also cause weird vibrations under acceleration. If the vibration is only noticeable when you apply the gas, is a good indicator that the problem lays in your drivetrain. Car shudders upon acceleration. …
When to use ATF + 4 in Jeep Wrangler?
ATF+4 was developed to succeed ATF+3 applications and degrade much slower. Where a transmission with ATF+3 might experience some shudder at around the 30k mile mark, the same trans with ATF+4 shouldn’t experience shudder until 80-100k miles (depending on driving conditions). In short, ATF+4 is a complete replacement for ATF+3.
This article will cover most of the possible causes of vibrations and what you need to determine to properly diagnose each. The most common cause for Jeep Wranglers to vibrate are improperly balanced tires. Other causes can be any of the following:
What was the problem with my 2002 Jeep Wrangler?
Start run, a little rough, but accelerating fine. After 10 of driving 2800 rpm problem returns. Code P0303 back. Drove the Jeep to the store in very cold temps. Ran rougher than before and got a new code P0135 02 Sensor error, P0300, P0304, P0303, P0305, P0306