Why does my Hyundai Tiburon radio not work?
I plugged the stocker back in and same thing, no power. Check the wire harness to the radio and those r all good. Also I have an edge cs multigauge obd-II reader and I’m not getting any power to that either. Any ideas guys what’s cause thing this? hmmmm….
What are the electrical problems on a Hyundai Veracruz?
Turn signal would not make noise when turned on….Replaced a module. Turn signal not making noise. Had this looked at 2 times before and was told they replaced the whole module (they didn’t)Went back again and was told out of warr. Contacted Hyundai and they made dealer replace at no charge (common problem)
How to open the yellow clip on Hyundai Tiburon?
Take some small gauge wire directly to the battery terminals, and connect to the correct pins on your radio harness/plug (yellow for power, black for ground). See if it even turns on with direct power. Rule out the HU itself first. EDIT, just read the above post. How did you open the yellow clip? How did you open the yellow clip?
Where are the fuses on a Hyundai Tiburon?
Click to expand… remove the BCM & fuse panel cover directly in front of your left knee, then get down and look towards the top left side of the BCM and you will see the yellow fuse cover. pull it out and flip the top up to access the fuse itself. (the yellow cover doesnt come out all the way).
What to do if your car radio won’t turn on?
ROOM LP did the trick! Take some small gauge wire directly to the battery terminals, and connect to the correct pins on your radio harness/plug (yellow for power, black for ground). See if it even turns on with direct power.
How do you connect a radio to a battery?
Take some small gauge wire directly to the battery terminals, and connect to the correct pins on your radio harness/plug (yellow for power, black for ground). See if it even turns on with direct power.
I plugged the stocker back in and same thing, no power. Check the wire harness to the radio and those r all good. Also I have an edge cs multigauge obd-II reader and I’m not getting any power to that either. Any ideas guys what’s cause thing this? hmmmm….
ROOM LP did the trick! Take some small gauge wire directly to the battery terminals, and connect to the correct pins on your radio harness/plug (yellow for power, black for ground). See if it even turns on with direct power.
Take some small gauge wire directly to the battery terminals, and connect to the correct pins on your radio harness/plug (yellow for power, black for ground). See if it even turns on with direct power.
What to do if your Hyundai Elantra battery is not working?
If the battery is under a certain charge then a jump will work and the lights will work but it won’t be able to recharge from the altenator .take it to a shop like Canadian tire or “the us equivalent ” and get then to check it. Usually done free
Why is the heated mirror on my Hyundai Elantra not working?
The driver’s side heated mirror has stopped working. I took it into the dealer,whom confirmed it to be not working,and they have ordered me a new mirror. 145-horsepower 1.8L I4 6-speed shiftable automatic FWD battery went dead over night , not even able to open the door by remote. dealer changed the battery under warranty.
Why is my Hyundai Elantra making a grinding noise?
Alternator bearing was throwing grease around engine compartment. Dealer replaced alternator. Blower motor is making a metal-on-metal grinding noise. I dropped the assembly and found nothing inside that could be making the sound. Part was ordered and replaced by me. Car had trouble starting. Battery was bad and needed replacement.
How to know if your Hyundai has air conditioner problem?
Symptoms: 1 Cooling would come and go while driving and sometimes not cool for a good while. 2 When idling, it may cool only for a little while and that would be while the ac clutch was engaged. 3 Check the low side pressure which was running about 50 lbs. 4 Suspected the ac high/low switch but had not purchased on yet.
Why does my Hyundai air conditioner blow warm air?
Since the system capacity is just 1.3 lbs, half a pound low is significant. For $160 and some pocket change they evacuated the system to get out all the air and water, and refilled it with refrigerant, oil, and a dye to help find future leaks. It worked better after that but it still wasn’t 100%. At stop lights, it would still blow warm air.
Symptoms: 1 Cooling would come and go while driving and sometimes not cool for a good while. 2 When idling, it may cool only for a little while and that would be while the ac clutch was engaged. 3 Check the low side pressure which was running about 50 lbs. 4 Suspected the ac high/low switch but had not purchased on yet.
Click to expand… remove the BCM & fuse panel cover directly in front of your left knee, then get down and look towards the top left side of the BCM and you will see the yellow fuse cover. pull it out and flip the top up to access the fuse itself. (the yellow cover doesnt come out all the way).
Take some small gauge wire directly to the battery terminals, and connect to the correct pins on your radio harness/plug (yellow for power, black for ground). See if it even turns on with direct power. Rule out the HU itself first. EDIT, just read the above post. How did you open the yellow clip? How did you open the yellow clip?