Why does my Hyundai Santa Fe gas gauge not work?

Subaru and Nissan factory training. In my 2008 Santa fe my check engine light came on and now my gas gauge says I am empty after fueling and does not show accurate fuel levels. The gauge fluxuates up and down if is works at all. Took th … read more

What to do if your fuel gauge is stuck?

If your fuel gauge is stuck full or empty this video may help to see if the problem is with the gauge itself, the wiring, or the sending unit. This video will show how to do this without dropping the tank or removing the IP cluster- if you can find a connector for the gauge and sending unit.

When do you need to replace the fuel gauge sender?

If your fuel gauge behaves erratically or is stuck on full or empty, you may need to replace the fuel gauge sender. 1. Fuel gauge behaves erratically 2. Fuel gauge stuck on empty 3. Fuel gauge stuck on full The fuel gauge sender is a component that is found in the gas tank of most road going vehicles.

What was the problem with my Hyundai Santa Fe?

The first problem was with the gas gauge. When the tank was about half full, the electronic gauge would register empt … read more Subaru and Nissan factory training. In my 2008 Santa fe my check engine light came on and now my gas gauge says I am empty after fueling and does not show accurate fuel levels.

How to fix fuel guage on a Hyundai Santa Fe?

Fixed error codes P2068, P0463 & P0464 on a 2007 Hyundai Santa Fe. The fuel gauge started working intermittent and replacing the sensors was recommended. Confirmed this with a OBD scan. PLEASE DO NOT ATTEMPT THIS REPAIR YOURSELF IF YOU ARE NOT HIGHLY MECHANICALLY INCLINED. HIRE A QUALIFIED MECHANIC FOR THIS REPAIR.

What should I do if my gas gauge is not working?

Note that some self-test steps may stop the gas gauge at 1/4, 1/2, and 3/4, as well. Fuel sender test. The fuel sender test should be conducted when the tank is lower than HALF, to prevent fuel splashing. Start by making sure the plug is clean, dry, and free of corrosion. Make sure the pins are straight and that the connector is fully seated.

How does the fuel gauge work in a car?

The fuel gauge in your automobile indicates the amount of fuel that remains in the gas tank. Some fuel gauges have an analog display while others have a digital or liquid crystal display. Electronic and software malfunctions may cause the fuel gauge in your automobile to inaccurately measure or display the amount of fuel remaining in the gas tank.

Why does my gas gauge keep pegging full?

The gas gauge might interpret voltage feedback from a dead sender as FULL or EMPTY, consequently pegging the gauge no matter the actual fuel level. Circuit Problems can cause the gas gauge to stop functioning normally.

How to fix fuel Guage on a 2007 Hyundai Santa Fe?

Please try again later. Fixed error codes P2068, P0463 & P0464 on a 2007 Hyundai Santa Fe. The fuel gauge started working intermittent and replacing the sensors was recommended. Confirmed this with a OBD scan. PLEASE DO NOT ATTEMPT THIS REPAIR YOURSELF IF YOU ARE NOT HIGHLY MECHANICALLY INCLINED. HIRE A QUALIFIED MECHANIC FOR THIS REPAIR.

Is the fuel level sensor on my Hyundai Santa Fe working?

Hyundai needs to do a recall………now!!! At 70,000 miles my 2009 Hyundai Santa Fe gas level sensor started acting up. When I fill the tank it registers empty and the and the low fuel light endicator comes on. It eventually comes up after using about 1/4 of the gas.

Why is the Check Engine light on on my Hyundai Santa Fe?

Since 2016 my fuel gauge in my 2009 Hyundai Santa Fe has been messed up. Check engine light is always on because of this. I cannot tell how much gas is in the tank ever!

Can a Hyundai Santa Fe run out of gas?

This can be very dangerous should a vehicle runs out of gas on the Highway. The Transportation Authority needs to take this matter up with Hyundai, and press for a recall and complete fix of the issue. Since 2016 my fuel gauge in my 2009 Hyundai Santa Fe has been messed up.

Why is my Santa Fe hard to start?

The fuel system concerns regarding the 2007 Hyundai Santa Fe had to do with the fuel gauge not reading correctly, the check engine light coming on, the car being hard to start after filling the fuel tank, the pump shutting off while filling the tank, the gas cap cover sticking, and the fuel gauge not reading at all.

What to do if your fuel gauge does not work?

1. Disconnect the fuel sender connector from the fuel sender. 2. Connect a 3.4 watt, 12V test bulb to terminals 2 and 3 on the wire harness side connector. 3. Turn the ignition switch to the ON, and then check that the bulb lights up and the fuel gauge needle moves to full. Attachments are only available to registered users. Register Here

How do you check the fuel gauge on a Honda Accord?

Connect a 3.4 watt, 12V test bulb to terminals 2 and 3 on the wire harness side connector. 3. Turn the ignition switch to the ON, and then check that the bulb lights up and the fuel gauge needle moves to full. Attachments are only available to registered users. Register Here FUEL SENDER 1.

What should I do if my Hyundai fuel gauge is wrong?

If you encounter a Hyundai Fuel gauge readings wrong or erratic condition on the vehicles listed below or find any of the following trouble codes: P0461, P0462, P0463, B1562, perform the tests shown below. What causes erratic fuel gauge readings or wrong fuel gauge readings?

What does the malfunction indicator light on a Hyundai mean?

On Hyundai cars, this is called the Malfunction Indicator Lamp (MIL), but you’ll probably know it as the check engine light. When the check engine warning light is illuminated it’s often accompanied by tell-tale signs that the engine is not working properly, such as a lack of power or stuttering as you press the accelerator.

What should fuel resistance be on Hyundai Sonata?

With the engine OFF for at least 40-secs and the key turned to the RUN position, back probe the fuel sender connector and measure the resistance between pins 1 and 3. Compare the readings to the resistance values below. 2011 and later Sonata Full 6-17Ω, ½ 70-75Ω, Warning light on 168-172Ω, Empty 198-202Ω

What happens to the fuel gauge when the tank is full?

When the tank is full and the float arm is at the top of its travel the variable resistor provides a low resistance. As the vehicle uses fuel and the float arm falls, resistance increases. The exact resistance the computer expects varies with year, make, model and whether the fuel gage is analog or digital.

Why does my gas gauge say empty after fueling?

In my 2008 Santa fe my check engine light came on and now my gas gauge says I am empty after fueling and does not show accurate fuel levels. The gauge fluxuates up and down if is works at all.

Why is the fuel gauge on my Hyundai Santa Fe not working?

Fuel gauge sending unit faulty and doesn’t give a correct reading to the level of fuel in the car. See all problems of the 2008 Hyundai Santa Fe . Both of the fuel gauges would drop down to empty wynfall while stationary. If I turn off my car then turn it back on it would stay empty even after being at the gas station.

In my 2008 Santa fe my check engine light came on and now my gas gauge says I am empty after fueling and does not show accurate fuel levels. The gauge fluxuates up and down if is works at all.

What kind of engine does Hyundai Santa Fe have?

I have a 2008 Hyundai Santa Fe 3.3 Litre Engine. For about 9 months the fuel gauge has either shown my truck is empty or it fluctuates while driving. I never know how much gas I have in the car so I k … read more I have a 2008 Hyundai Sante Fe with about 65,000 miles. Car is serviced regularly. The first problem was with the gas gauge.

What does the Check Engine light on a Santa Fe mean?

These are automotive computer codes stored by the ECM, also known as the OBD (on-board computer diagnostic system) in your Santa Fe. There are hundreds of different codes that your check engine light can represent.

Is there recall on Hyundai Santa Fe fuel level sensor?

THIS IS RIDICULOUS AND DANGEROUS, AND HYUNDAI NEEDS TO RECALL THE FUEL LEVEL SENSORS DUE TO SAFETY PURPOSES. BECAUSE OF THIS NEAR ACCIDENT, I WENT AHEAD AND REPLACED BOTH SENSORS, COST $400.

Navigation