Why does my Honda CD player not work?
DVD, CD Drive does not work or read CD’s. We have seen this amplifier in shop for blown channels, usually after attempted aftermarket amplifier installation. NO longer repair Honda car stereos. See Help for stereo CodE, removal, installation, replacement, repair and more. Matsushita CD changer jammed, will not accept, eject or play CD’s.
How do you eject a CD from a car?
Check your owner’s manual – you may have more than one fuse that controls the CD and/or the radio and you may need to remove all the related fuses. Turn your ignition on to the accessory position. Hold the eject button down for 2 or 3 minutes. Depending on your make/model, the eject button may flash.
Why does my CD player not eject a CD?
The rubber roller rides on a metal axle, and over time, the rubber became loose, allowing the metal axle to spin independently of the rubber- when the CD was inserted or an attempt was made to eject it, the metal axle spun, but did not move the rubber, which is what makes contact with the CD.
How do you remove a CD from a head unit?
A note on the ribbon cable that connects the CD mechanism to the head unit- I did not show it’s removal, but it is fairly simple. Using a small pair of pliers or a flat blade screwdriver, push the plastic clips on either end of the cable TOWARD the side of the harness that the cable plugs into.
How do you eject a CD from a Honda CD player?
Start the car. Hold the shutter with the bent ends pointing down in one hand. Insert one end of the shutter into the front-loading slot of the Honda’s CD player as far as you can. Press and hold in the “Eject” button on the player’s control panel with your free hand. Push down on the shutter to catch an edge of the stuck CD’s center hole.
What to do if your CD player won’t eject?
Push down on the shutter to catch an edge of the stuck CD’s center hole. Pull the shutter out of the front-loading slot. Stop pulling the shutter when an edge of the CD can be seen.
How long does it take to eject a CD from a car?
Hold the eject button down for 2 or 3 minutes. Depending on your make/model, the eject button may flash.
What causes a CD to get stuck in the CD changer?
Risky variation of the fuse tip that fixed a CD changer. Rbronosky in the Axiom 6-CD Changer discussion figured out which fuse controlled the CD changer. When pulling the fuse didn’t reset the changer, he turned the ignition on just enough to run the radio.
How do you put a radio on a Honda Accord?
Go to https://radio-navicode.honda.com/ and click on the tab labeled “Get codes.”. Input your radio’s serial number, vehicle’s VIN and your personal information, then click “Submit.”. Write down the security code. Turn the ignition switch to the “On” position and turn on the radio.
How do I enter the security code on my Honda radio?
Enter the security code using the soft buttons on the touch screen display. Turn off the ignition when the radio resumes normal operation. If you input the code incorrectly 10 times, you must wait one hour before attempting to enter the code again.
How do I Reset my Honda Accord immobilizer?
Turn the radio on by pressing in on the volume control knob. After 10 seconds, turn the radio off. Press and hold the power button for two to five seconds and watch the radio display.
What to do if your Honda CD player is not working?
Check the metal strip inside the fuse. If it is broken or burned, then replace the fuse with a new fuse of the same amperage. If your CD player still does not power on, then the CD player unit has malfunctioned and needs to be replaced. Insert a CD into the Honda CD player. If the CD skips or has trouble playing, eject the CD.
How to find the radio code on a Honda Accord?
If u can’t seem to find the code anywhere do this. 1st, if it says error or ErrE as my display shwoed, go the the passenger fuse box and remove the radio fuse. (Mine was fuse #9, 20A cig lighter/radio fuse) Check your manual.if you don’t have the same exact car. I took it out for a few seconds. Reinstalled it and the radio now said CODE.
Where is the fuse on a Honda CD player?
Open the fuse panel underneath the steering column and use the fuse diagram on the underside of the fuse cover to locate the fuse for the radio/CD player. Pull the fuse out of the fuse panel using the fuse puller mounted in the fuse box. Check the metal strip inside the fuse.
How do you replace a CD player in a Honda Accord?
Before replacing anything, however, you should troubleshoot the CD player to make sure that it is the problem and not the CD. Turn the ignition key to the “II” position on your Honda to operate the accessory components.