Why does my car stall immediately after starting?
Rarely I have to rev at stops or the idle drops too low and stalls. If I punch the gas very quickly it revs and drops quickly and then stalls. Starting has a success rate of about 50% without revving. If it stalls, I must rev the engine to start.
Why does my Jeep stall when I start the engine?
If it starts, the fuel pump is the problem. If not, the engine should be checked for spark. It could be a sensor or computer-related problem. To be absolutely sure, raise and support the back of the Jeep on jack stands, unless the height allows you to crawl under the back without raising it.
What to do when your Harley starts stalling?
Start the bike cold. Mist the intake flanges with brake cleaner. If your bike’s idle drops, or the engine stalls, you have an intake leak. If this is the case, replace the intake seals along with the front & rear intake flanges. If the bike passes the intake test; have the dealer or your mechanic scan the m/c for possible codes.
Why does my Harley Davidson stall when I idle?
It always starts easily when cold and idles well, but after a few minutes, if I’m idling awhile to get out of my driveway, the idle will fall and the engine will threaten to stall. If it does stall it’s hard to get started again, I have to give it a little throttle to get it to start and stay running.
If it starts, the fuel pump is the problem. If not, the engine should be checked for spark. It could be a sensor or computer-related problem. To be absolutely sure, raise and support the back of the Jeep on jack stands, unless the height allows you to crawl under the back without raising it.
When did the stalling problem start in my car?
Most stalling problems pertain to model years starting from the mid-1990s all the way to recent model years, and have occurred with virtually every trim level.
What should I do about my Jeep Cherokee stalling?
A deep dive into actual solutions offered by the most trusted sources, fellow Jeep Cherokee owners like you.
When did the Jeep Cherokee XJ come out?
The Jeep Cherokee (XJ) is a compact SUV that was manufactured and marketed by Jeep from 1997 to 2001. Sharing the name of the original full-size SJ model, but without a traditional body-on-frame chassis, the XJ instead featured a light-weight unibody design.
Why does my engine start but then stop?
A Bad Camshaft Position Sensor. A bad camshaft position (CMP) sensor can produce different types of symptoms and cause the engine to stall immediately after starting or intermittently. A bad camshaft sensor is likely to trigger the check engine light (CEL).
Is there check engine light for intermittent stalling?
Many times, there will be no check engine light and no fault codes to give you a clue as to what might be causing the engine to stall. So the trick to diagnosing an intermittent stalling problem is to catch the vehicle when it’s acting up — and that rarely happens when you have the vehicle in your shop.
What should I do if my engine stalls?
It’s worth checking with a know working oil pressure gauge, so that you can get the real readings (i.e. 40 psi… If you are feeling vibrations in the drivetrain when only going 20 to 40 miles then the problem is inside the transmission. If you just had the transmission rebuilt then take it back to the rebuilder to diagnose the problem…
A Bad Camshaft Position Sensor. A bad camshaft position (CMP) sensor can produce different types of symptoms and cause the engine to stall immediately after starting or intermittently. A bad camshaft sensor is likely to trigger the check engine light (CEL).
What does it mean when your car stalls at idle?
If the Engine Stalls at Idle Unless You Press the Accelerator IV. If the Engine Starts When Cold but Stops When Warm V. If the Engine Stalls Intermittently I. If Your Engine Stops Immediately After it Starts Your engine may stop as soon as you let the key return from the Start to the Run position.
It’s worth checking with a know working oil pressure gauge, so that you can get the real readings (i.e. 40 psi… If you are feeling vibrations in the drivetrain when only going 20 to 40 miles then the problem is inside the transmission. If you just had the transmission rebuilt then take it back to the rebuilder to diagnose the problem…
What is the diagnostic code for engine stall?
Diagnostic trouble codes P0120, P0121, P0122, P0123, and P0124 are what will commonly appear. The engine can stall for no reason and without any warning. This happens when the TPS gives incorrect information to the ECM. The engine can stall at high speed, at low speed, or even at idle.
Can a computer malfunction and cause a stall?
An engine control unit, engine control module, or powertrain control module (ECU, ECM, or PCM respectively) is the computer that manages the main engine parameters and programming for the vehicle. Although rare, it is possible for the ECU to malfunction and cause a stall.
What causes a car engine to stall after starting?
Engine stalling shortly after starting. The engine hesitates or drags while under load or idle. Hesitation and jerking during acceleration. The engine hiccups. Excessively rich or lean idling. A sensor that has been contaminated by fuel, varnish or dirt will under report airflow.
What causes a Mercedes Benz to not start?
In most cases you will get a fault code related to one of the following: 1 ECM / PCM computer failure 2 Camshaft position sensor 3 Shifter Selector module 4 Fault codes related to driver authorization or immobilizer 5 Electrical problems
When does a 99 6-0l engine start and die?
It will start right up, then dies after going up to about 1000 RPM for 2 seconds. It will start everytime then die. I’ve replaced the fuel pump, fuel filter, fuel regulator. I’ve got another 99 6.0L that i’ve swapped the MAF, MAP, Idle Air, Throttle Position sensor, both computers, all relays, nothing changes the behavior.
Can a faulty manifold sensor cause engine stall?
A faulty manifold pressure sensor has symptoms that closely resemble; a vehicle with injector problems or low compression problems. If the (MAP) sensor is not reading accurately; the (PCM) may add too much fuel or not enough. This again will cause engine stalling.
Why does my Harley Davidson hard start when hot?
Hard starting when HOT, but the engine spins up fine, means either lack of fuel or weak, no spark. If your Dyna is EFI, your fuel pump is losing prime/pressure due to fuel line leak…look here: http://www.hdtimeline.com/diagnosti…lated/979-engine_dies_and_runs_in_spurts.html
What causes a car to start but not keep running?
The engine requires the right amount of air and fuel to mix together for ignition. If there is a fuel leak somewhere, then the correct amount of fuel may not make it to the combustion chamber. This might be enough to allow the engine to start, but not keep running.
Why does my car stall at highway speeds?
The engine may start and idle fine, but run out of power or even stall at highway speeds. If the engine starts right back up after stalling, the likely cause is low fuel volume delivery because of a weak pump. If the engine is running normally one minute, but suddenly quits, loss of ignition may be the problem.
What causes an engine to stall in cold weather?
Engine stalling problems can be hard to find and are often sensor or temperature related. Engine stalling is more likely to occur during cold weather or when starting a cold engine. So, this kind of engine stalling problem often means the engine is not getting enough fuel and/or too much air.
What are the symptoms of an engine stall?
Here are some of the most common symptoms of, a faulty mass airflow (MAF) sensor; The engine is very hard to start or turn over. Engine stalling shortly after starting. The engine hesitates or drags while under load or idle. Hesitation and jerking during acceleration.
Rarely I have to rev at stops or the idle drops too low and stalls. If I punch the gas very quickly it revs and drops quickly and then stalls. Starting has a success rate of about 50% without revving. If it stalls, I must rev the engine to start.
Why does my GMC Sierra stall at 30 mph?
Never threw a service engine light or a code and would readily re start. 2 weeks ago it quit at 30 mph, wouldn’t restart and SES lit up. Code indicated crank positioning sensor. Had it replaced and so far so good. If yours behaves as mine did it could be a while before you get a traceable code. I own a 1998 GM Sierra 5.7L 2wd automatic.
When did Chevy Silverado start stalling at highway speeds?
April 2007, Stalling ocurrred at highway speeds (first time), diagnosis was faulty PRV and repaired. Stalling contiuned intermittently after replacement.
Many times, there will be no check engine light and no fault codes to give you a clue as to what might be causing the engine to stall. So the trick to diagnosing an intermittent stalling problem is to catch the vehicle when it’s acting up — and that rarely happens when you have the vehicle in your shop.
What should I do if my Schrader is stalling?
Take a small screwdriver and push in on the Schrader to see if fuel comes out in force. If not, hold the Schrader in and have the helper turn the key on. Be ready to release the Schrader if there is fuel pressure, for it will come out fairly steady. If there is no pressure, replace the cap and check the relay.