Why does my bike take so long to kick?
Possible causes: * Low/no fuel. If your ride has a fuel “petcock” make sure that it hasn’t been set to Off, or if you’ve not much fuel in the tank, set it to Reserve (the normal “On” setting doesn’t draw fuel from the bottom of the tank). * Blocked fuel line/filter.
What happens if the fuse on my electric bike fails?
The fuse can fail, just because, but normally if it does, there is a problem with the battery or wiring. The fuse is there to protect your battery and bike from an overload of power that can cause intense heat or fire. A simple voltmeter test can give you a general idea if the battery is holding juice and if the fuse is bad.
Why does my bike start but no power?
Is is it the fuses, you need to find out whats blowing them. bad earth, short etc. Check all connections and especially earth points. Water and moisture in couplings too. Check the battey next..Its NOT the battery that runs the bike or the lights etc, its the generator. The battery is there to start the bike, no other reason.
Why does my motorcycle keep blowing fuses?
If fuses continue to blow after you replace them, you likely have a more serious electrical issue somewhere in the bike’s wiring. The line between the petcock and the engine can sustain damage, too, which keeps the system from operating properly.
What to do if your bike battery wont turn?
Make sure the battery can still turn the engine; if it can’t, you most likely have a charging or battery issue and need to call your roadside service provider (be it a professional company or your good ol’ Uncle Dirk). If the battery is OK, these are the steps to take:
Why does my bike not turn on when I press the power button?
A low charge or a loose battery connection can cause your bike to not turn on when you press MODE or the power button. Follow the steps below to check that the battery is charged and correctly installed. Check the battery charge level. With the battery in place on the bike, use the key to turn on the battery.
If fuses continue to blow after you replace them, you likely have a more serious electrical issue somewhere in the bike’s wiring. The line between the petcock and the engine can sustain damage, too, which keeps the system from operating properly.
Is there any power at the main fuse?
With a continuity tester I pierced all positive cable that lead to the front of the bike with no juice at all. Brian : is there power at the main fuse? Customer: I just bought this bike a few days ago and almost right away this thing quit working.
What should I do if my bike wont start?
Charge the battery or replace it if it’s dead. Am easy way to test your battery is by checking the voltage-drop with a multimeter as you try starting the bike. If your fully charged battery drops below 11,5 volts under load (while you crank the starter), it needs to be replaced.