Why does Honda CBR 250R have higher RPM?
The bike is equipped with auto choke facility; hence everytime the bike is started there’s more fuel let in by the ECU & hence the higher RPM; once the ECU learns that the bike is warm enough (not optimal operating temperature) the choke is cut off & hence the RPM falls down Q.
Do you have to pay ASC for Honda CBR 250R?
Usually ASC don’t charge on such things, but there’re instances where they’ve quoted even ridiculous amounts. Also, take care of the chain when riding in rains by inspecting the chain for every 750-1000 Km thoroughly (and 1400-1500 on dry weather).
What kind of oil does Honda CBR 250R use?
HMSI 10W30 Engine oil is what Honda supplies & recommends to use for CBR 250R, cost around Rs 556 per liter. I’ve used this engine oil right from 9980 Km all way up to 34537 Km & have used in extreme heat (read around 45+ degree in AP) with extremely fast riding & the engine oil proved good.
What happens when you hit start on a bike?
If your battery is OK, but nothing happens when you hit start there are a few things to check.
What should I do if my Honda 97 dies?
Really amazing. After that and a spray down with carb cleaner and compressed air, new carb kit and an inline fuel filter installed, my 97 started like a champ. Test run afterwards showed the symptoms persist. See title: runs fine for about 10 minutes then starts cutting out, backfires, and dies.
What did I do to make my Honda 97 start?
Boiled the carb in lemon juice yesterday which worked as advertised. Really amazing. After that and a spray down with carb cleaner and compressed air, new carb kit and an inline fuel filter installed, my 97 started like a champ.
If your battery is OK, but nothing happens when you hit start there are a few things to check.
What to do if your Honda starts up and backfires?
Cap was definitely plugged. I put the red straw end of a can of carb cleaner into the vent hole and sprayed down into it. Nothing, except the pressure that built up in the cap and blew the cleaner back out the top. Then I reamed the two small holes under the cap w/small drill bits and did the main top vent likewise.