Why are my instrument clusters and dash lights not working?

Why are my instrument clusters and dash lights not working?

I recently retrofitted a virtual cockpit but as it was faulty, I ended up switching instrument clusters a few times which ultimately meant the odometer was incorrect. Rather than use one of the few services to increase the mileage, I purchased the required tool to correct the odometer myself. … Hello all! HELP!

What to do if your dash light does not work?

#Test the dashboard light bulbs. If the fuses are working properly, check for a blown bulb in the dashboard. Following the manufacturer’s instructions, disconnect the battery while working on the dash, remove the faceplate covering your vehicle’s dashboard gauge panel. Remove the screws holding the plate on. Carefully remove the faceplate.

Where is the control switch for the dashboard lights?

Most vehicles have a dashboard lights control switch that will dim the dashboard lights, as well as turn them off. Check the control switch, which should be located on the console near the steering column or part of the headlight switch. [ [Image:Fix Dashboard Lights That Won’t Light Step 1 Version 3.jpg|center]]

What to do if your dash gauges are not working?

You can’t post conmments that contain an email address. An expert who has achieved level 1. An expert that has 1 follower. An expert whose answer got voted for 2 times. Pull out and re-set the DIC fuse. It’s i the fuse box under the hood. This solution worked for me.Kind of funny the DIC was still working but all the guages weren’t.

#Test the dashboard light bulbs. If the fuses are working properly, check for a blown bulb in the dashboard. Following the manufacturer’s instructions, disconnect the battery while working on the dash, remove the faceplate covering your vehicle’s dashboard gauge panel. Remove the screws holding the plate on. Carefully remove the faceplate.

Most vehicles have a dashboard lights control switch that will dim the dashboard lights, as well as turn them off. Check the control switch, which should be located on the console near the steering column or part of the headlight switch. [ [Image:Fix Dashboard Lights That Won’t Light Step 1 Version 3.jpg|center]]

What should I do if my Porsche door lock is not working?

Perhaps a dealer with a Porsche diagnistic computer could pin the problem down to the precise part by acutating the locking system components one component at a time and look for what piece triggers a fault. Otherwise, I would replace the door lock if I didn’t want to spend money paying someone to run further diagnostics.

What causes the cluster gauges to stop working?

In one of the youtube videos I watched, the guy mentioned that there are also three small surface mount resistors that control power to the entire cluster, and his were causing the entire gauge cluster to go dead. He reflowed them and corrected the issue. I had a issue pretty similar to this as well.