Who has gone aftermarket for a 3406E cylinder head?
My current original head on my 3406E has cracks running inbetween every valve crossing over every injector hole, would this head “reman” ok? Which is why I would prefer to have my own head re-done and wait a while for it… when the time comes. Which is why I would prefer to have my own head re-done and wait a while for it… when the time comes.
What kind of engine does a Caterpillar 3406E have?
Caterpillar 3406E Engine Specifications. Fuel: Diesel. Liter: 14.6. Cubic Inch Displacement: 893. Cylinder Bore Diameter: 5.4000-5.4020″ (137.16-137.211 MM) Stroke: 6.500″ (165.1 MM) Cylinder Configuration: L6. Engine Comments: 3406E truck, OHC, 24 Valve.
Can a cat Reman cylinder head be taken back?
Yes , ring issue for sure! Yup, rings, and they should all hold in the liner up to a million miles. Unless it got dusted, hence the liner pulling in half and the other loose pistons. Always use Cat ReMan heads, and yes they take em all back as core, but melt and scrap busted ones.
How much does a cat head rebuild cost?
We work with a guy who had a valve and guide come apart a few hundred miles after his cat rebuild with a cat head. Our shop has only ever done 1 rebuild with aftermarket parts. It lasted 20,000 kms and the liner broke apart and then pounded into the head. Click to expand… The best I can figure for a new head is $3700.
How to adjust the exhaust valve on a 3406E?
Make an adjustment to the valve lash on the exhaust valves for cylinders 1, 3, and 5. Loosen the valve adjustment locknut (1) . Place the appropriate feeler gauge (5) between the exhaust rocker arm and the exhaust valve bridge. Turn the exhaust adjustment screw (2) while the valve adjustment locknut (1) is being held from turning.
Where is the No 6 piston on a 3406E?
Remove the top center bolt, and turn the flywheel by 360 degrees in the direction of the engine’s rotation. This will position the No. 6 piston at the top center on the compression stroke.
Where is the timing pin on a 3406E?
After you adjust cylinders 1, 3, and 5, reset the timing pin and turn the flywheel for 360 degrees in the direction of the engine’s rotation. This will position the No. 6 piston at the top center on the compression stroke. Ensure that the timing pin has located the timing hole that is in the flywheel.
Where can I find Caterpillar 3406 engine parts?
Caterpillar 3406 Engine Parts All manufacturers’ names, symbols, and descriptions are for reference ® only. It is not implied that any part is the product of these manufacturers. Caterpillar®, CAT are registered trademarks of Caterpillar, Inc. TRP®Engine Parts Catalog ©2013 DON’T SEE A PRODUCT YOU NEED?
When to replace fuel injector seals and washers?
If the O-ring fitted to the injector is the problem; then replacing this O-ring will usually fix the leak. If the injector body; nozzle or internal components are cracked; then a new or refurbished injector is your only option. Replacement fuel injector seals and washers are cheap and are, fairly easy to install.