Where to find the timing mark on a crankshaft pulley?
Remove valve cover and #1 spark plug (or all spark plugs). Rotate engine until #1 piston is at Top Dead Center. Look for the timing mark at 6 o’clock. There should be a thin notch (catch your thumb nail in it) in the edge of the rear flange of the pulley. If you have a slightly wider than normal v-belt it may shield your view of this mark.
Do you need a crankshaft pulley alignment tool?
TIMING CRANKSHAFT PULLEY If you have a ford vehicle it is very possible that you have a no pin engine which means that if you remove the crankshaft pulley / harmonic balancer you will need special tool to align the crankshaft pulley and a special tool to get it tight ( to hold the flywheel).
How do you make timing marks on a MGB pulley?
File or grind a permanent notch at that position. You can do this to make a timing mark on the pulley at 10 o’clock to match the late MGB timing cover. Without removing the cylinder head you can use a piston stop to do the same thing.
Where do you find the timing mark on a push mower?
Rotate engine until #1 piston is at Top Dead Center. Look for the timing mark at 6 o’clock. There should be a thin notch (catch your thumb nail in it) in the edge of the rear flange of the pulley. If you have a slightly wider than normal v-belt it may shield your view of this mark.
What is the timing crankshaft pulley alignment tool?
FORD CRANKSHAFT PULLEY ALIGNMENT TOOL. TIMING CRANKSHAFT PULLEY If you have a ford vehicle it is very possible that you have a no pin engine which means that if you remove the crankshaft pulley / harmonic balancer you will need special tool to align the crankshaft pulley and a special tool to get it tight ( to hold the flywheel).
How to remove a pulley from a crankshaft?
CAUTION Do not use a hammer or a screwdriver to remove the viscous damper. These tools can damage the damper. Remove two of the vibration damper and crankshaft pulley retaining capscrews. Install two guide studs, Part Number 3376696, in the holes. Remove the remaining three capscrews, clamping plate, pulley, and damper. Inspect for Reuse
How to seal a crankshaft pulley ism and ISME?
ISM, ISMe, and QSM11 Crankshaft Seal, Front Section 1 – Cylinder Block – Group 01 Page 1-53 Orientate the four punch marks on the clamping ring at the 11:30 o’clock location. Apply a coating of thread sealant, Part Number 3823494, to the six mounting capscrews.
What are the guide studs for a crankshaft pulley?
Make sure the mounting surfaces of the crankshaft nose, the vibration damper, and the pulley are clean, dry, and free of burrs. Install two guide studs, Part Number 3376696, in the crankshaft nose.