Where is the transmission control module on a 2001 Dodge Durango?
Right next to the radiator in the gap on the passengers side. It has a large heat sink on it.
What transmission does a 2001 Dodge Durango have?
five-speed automatic transmission
A 235-horsepower 4.7-liter V-8 is the base engine and teams with a five-speed automatic transmission.
Where is the TCM located on a 2000 Dodge Durango?
on the 2000 its on the passenger side to the right of the glove box. older models of dakotas have them on the drivers side.
Where is the TCM located on a 2002 Dodge Dakota?
The transfer case control module is under the dash, just right of the stearing column. It’s a small blue plastic box with three plugs. The transmission control module is in front of your air box on the right side, maybe mounted behind the headlight.
How to remove transmission from Dodge Durango 4 x 4?
(25) Remove bolts securing rear support and cushion to transmission and crossmember. Raise transmission slightly, slide exhaust hanger arm from bracket (Fig. 74) and remove rear support. (26) Remove bolts attaching crossmember to frame and remove crossmember. (27) On 4 x 4 models, disconnect vent hose from transfer case.
Can a overdrive unit be removed from a Dodge Durango?
The overdrive unit can be removed and serviced separately. It is not necessary to remove the entire transmission assembly to perform overdrive unit repairs. CAUTION: The transmission and torque converter must be removed as an assembly to avoid component damage.
How to remove transfer case from Dodge Durango?
Retain fill tube seal. On 4 x 4 models, it will also be necessary to remove bolt attaching transfer case vent tube to converter housing (Fig. 73). (19) Rotate crankshaft in clockwise direction until converter bolts are accessible. Then remove bolts one at a time. Rotate crankshaft with socket wrench on dampener bolt.
Do you have to remove transmission and torque converter?
CAUTION: The transmission and torque converter must be removed as an assembly to avoid component damage. The converter drive plate, pump bushing, or oil seal can be damaged if the converter is left attached to the driveplate during removal. (1) Disconnect battery negative cable.