Where is the tail light on a Harley Davidson?

Where is the tail light on a Harley Davidson?

The blue wire (?) in the fender connector should be the tail light (running light). You should have 12Vdc there. Does your bike have the brake light harness that makes the rear turn signals brake lights also? Check under the seat for the wiring harness? neither the hand break lever or the foot lever are doing anything.

Why is the rear tail light not working?

neither the hand break lever or the foot lever are doing anything. The rear running light is not working either. I checked the connector at the rear tail light. It seemed ok, no rust or corrosion. I dident notice any breaks in the wire running under the rear fender. Under your seat there should be a 3 or 4 wire connector to the rear fender.

How do you reset the turn signal on a Dyna Glide?

Press left turn signal switch once, and light will flash a number of times to indicate an error code. There is 1.5 seconds between flashes to indicate 1st and 2nd digit of codes and four second pause between codes. Press and hold left switch down for five seconds, and light will flash twice to indicate the TSSM is reset. Turn ignition to off.

Are there rear running lights on a Harley?

You don’t say anything about year but unless something has changed, rear turn signals on Harley’s have never been running lights unless you add the kit to make them so. Can’t figure it out. Brake light works, rear turns work, but no rear running lights.

The blue wire (?) in the fender connector should be the tail light (running light). You should have 12Vdc there. Does your bike have the brake light harness that makes the rear turn signals brake lights also? Check under the seat for the wiring harness? neither the hand break lever or the foot lever are doing anything.

neither the hand break lever or the foot lever are doing anything. The rear running light is not working either. I checked the connector at the rear tail light. It seemed ok, no rust or corrosion. I dident notice any breaks in the wire running under the rear fender. Under your seat there should be a 3 or 4 wire connector to the rear fender.

Press left turn signal switch once, and light will flash a number of times to indicate an error code. There is 1.5 seconds between flashes to indicate 1st and 2nd digit of codes and four second pause between codes. Press and hold left switch down for five seconds, and light will flash twice to indicate the TSSM is reset. Turn ignition to off.

How to test a Harley Davidson brake light switch?

Ok , so working out issues on this 1989 FLHTCU I fixed the brake lights , the wires in the left side panel had to be cleaned a soldered then they stopped working again. I did a repeat on the test light still had power to the wires at the switch on the rear.