Where is the stereo located on the dash?
Find the edges of the dash panel where the stereo is located. Look up from the bottom to find the two rectangular holes for a flat tool, such as a screwdriver. Insert the end of a screwdriver into one of the rectangular holes and pry out the panel. Repeat this step for the other rectangular hole.
How to fix ticking sound in the dashboard?
How To Fix Mercedes-Benz Ticking Sound in the Dashboard Problem 1 Symptoms: Noise Under the Dash. 2 Problem: The clicking sound and the rest of the symptoms may be attributed to a broken stepper motor lever or the footwell damper linkage. 3 Solution: If it is indeed the linkage that’s broken, you have to replace it. …
How do you remove a stereo from a car?
Insert the end of a screwdriver into the edges of the panel and gently pry up. Pull off the air conditioning knob in the center of the console to expose a Phillips screw. Remove the screw with a Phillips screwdriver. You will need to remove this screw to pull out the stereo assembly unit from the dash.
How do you remove the dash from a car?
Release the dash from its clips to remove it. Disconnect the hood release handle from the lower dash, prying out its clip, releasing the cable from the handle and prying off the plastic housing. Separate the diagnostic connector, located at the left edge of the dash. Remove all the screws and pins for the lower dash and remove it.
When does the ticking sound in the dashboard go away?
The sound lasts for about 20 seconds then goes away after approximately 5 minutes. Later on, however, the ticking returns and repeats its cycle. Other times, you may feel that the fan speed is not normal. It speeds up and slows down all of a sudden. You may also notice that there is no air blowing on the floor.
What can I do about the clicking noise in the dash?
Behind the engine. If you lean over the engine you can see the cable where it comes through the firewall and operates a valve on a hose. Turn the heat knob all the way to hot to extend the cable all the way out and put a small amount of grease on the cable and rub in with your fingers. Don’t overdo the grease, a little dab will do ya. D
How to fix ticking sound in Mercedes-Benz dashboard?
Loosen the screws to about 90 degrees. Locate the other two screws under the AC controller then remove them using the T20 torx screwdriver. Detach the center console as far back as you can. Above the radio, locate the small plastic tabs on the left side of the AC vents.