Where is the spark plug on a Kawasaki Lakota 300?

Where is the spark plug on a Kawasaki Lakota 300?

Check the spark plug next. The Lakota 300 has one spark plug, located inside the engine’s single cylinder. Remove the spark plug cap and unscrew the plug using a spark plug wrench. If the insulator tip is dirty or burned, replace the spark plug with a new NGK D8EA plug. Measure the spark plug gap with a wire thickness gauge.

Why is my Kawasaki Lakota 300 not running?

Unscrew the lower end of the carburetor drain hose and run it into a collection container. Turn out the drain screw two or three times to drain the carburetor. If drained fuel contains water, dirt or gummy fuel, then the fuel system has been contaminated.

What to do when your engine has no spark?

Insert a spark plug tester into the plug boot and ground it on a piece of metal on the engine. Finally, Have someone crank the engine and watch for spark. Remove one of the coils from the spark plug. Use an extra spark plug. A spark plug tester. Or even a screwdriver in the end of the coil.

What kind of battery does a Kawasaki Lakota 300 have?

The Lakota 300 takes a 12-volt, 14 ampere-hour battery. Use a separately powered battery charger to charge the battery fully to 12.8 volts. Reverse battery removal steps to reinstall the Lakota’s battery. Try to start the engine again.

Check the spark plug next. The Lakota 300 has one spark plug, located inside the engine’s single cylinder. Remove the spark plug cap and unscrew the plug using a spark plug wrench. If the insulator tip is dirty or burned, replace the spark plug with a new NGK D8EA plug. Measure the spark plug gap with a wire thickness gauge.

What to do if battery on Kawasaki Lakota 300 goes bad?

Clean the battery terminals if buildup has collected. Use baking soda mixed with water for this cleaning. Replace the battery if it is damaged or if the terminals are cracked. The Lakota 300 takes a 12-volt, 14 ampere-hour battery. Use a separately powered battery charger to charge the battery fully to 12.8 volts.

Where is the fuse on the Kawasaki Lakota 300?

Check the Lakota 300’s electrical system if the quad experiences starting problems. Begin this check with the main fuse, located beneath the rear portion of the Lakota seat on the battery holder. Remove the main fuse using a pair of pliers and inspect.

Where is the air cleaner on a Kawasaki Lakota 300?

Locate the air element cleaner next, located on the left side of the Lakota near the engine. Remove the plugs and air cleaner cover screws and cover to access the air cleaner. Pull the air cleaner element carefully from its housing and check the inlet tract for dirt.