Where is the oil drain plug on a 2003 Harley Davidson Road King?
The drain plug is located under the round derby cover on the primary. Place your oil catch pan below the plug and drain the primary fluid completely.
Where is the oil plug on a Harley Road King?
Place your oil pan beneath the motor oil drain plug. The drain plug is located on the right side of the motor and to the rear of the frame. Remove the drain plug with a Torx socket and replace the plug’s o-ring.
Where do you drain oil on a Harley Davidson?
Drain the transmission oil. The transmission drain plug it centered directly above the shock absorbers. Because both the engine and transmission drain plugs are so close to each other, they can easily be drained simultaneously into the same drain pan. Stand your Harley upright.
When to replace the drain plug on a Harley Davidson?
If the engine oil or transmission oil drain plug allocation becomes stripped on a touring model, the entire oil pan may need to be replaced. This holds true for, both, Twin Cams and M8 Touring models. If the primary drain plug allocation becomes stripped, the inner primary case may need replacement.
When to remove oil plugs on Harley Davidson?
It is of utmost importance to remove the engine oil and transmission oil fill plugs along with the primary derby cover; either before draining the oils or before the drain plugs are reinstalled. This will help to avoid confusion as to whether or not the oil has been replenished before attempting to start the motorcycle.
Where is the drain plug in an engine?
An oil drain plug is a large nut usually located in the lowest point of the oil pan at the bottom of the engine where all engine oil capacity rests. The reason as to why it is located here is for it to drain the maximum amount of oil when changing engine oil.
What’s the best way to remove an oil drain plug?
Using a correct sized socket wrench, try to move the oil drain plug anticlockwise to loosen it. Once you have drained all the oil in the oil pan, use a clean cloth to clean the teeth of the oil pan and put a new gasket. Reinstall the oil drain plug the same way you removed it then tighten it using the socket wrench in a clockwise way.
How big is the oil drain plug on a motorcycle?
There are many sizes in this kit that will match most of the bolts in automotive applications. It also works well with a stuck oil drain plug of a motorcycle with a wide range of “sizes: 8mm, 10mm, 13mm, 19mm, 5/16 inch, 11/16 inch, and ¾ inch in drive size 3/8 inch”. Where Is The Drain Plug Located?
How to change the oil on a Harley Davidson Road King?
Harley Davidson Road King oil and filter change. You will need 4 quarts of mobile 1, 20-50MC oil and HD oil filter. Tools needed 5/8 socket, and a Harley oil filter wrench. Pan and oil funnel. All the steps from draining oil and filling too checking levels. Loading…