Where is the OBD2 port on a discovery 2?
OBD2 port Land Rover Discovery 2 (1995 – 2005) – Find your plug ! Where is my OBD2 port ? All vehicles are equipped with an OBD port to which you can connect your klavkarr diagnostic case.
Can a dash cam connect to the OBD port?
So yes, the OBD port’s power pin (battery positive 16): So except for the fact that you will/could drain the battery, connecting a dash cam to the ODB II port should not give any problems.
Are there replacement parts for the OBD II system?
No. Aftermarket parts manufacturers continue to produce replacement parts to fit most vehicles. These parts are required to be functionally equivalent to the original equipment manufacturer (OEM) parts and are, therefore, compatible with the vehicle’s OBD II system.
What happens when OBD 2 system detects problem?
If the OBD II system has detected a problem, the vehicle owner would be expected to have the problem repaired in a timely fashion. Correction of the problem would be verified through the OBD data transmitted after the vehicle has been serviced.
What is the location of the OBD port?
The OBD Port, is the location where you can plug in any OBD tool into the vehicle to pull vehicle information. It is also the primary location of tracking devices such as dongles as the port provides ongoing power to the device. There are two generations of OBD ports, OBD1 and OBD-ii aka OBD2.
Is it illegal to disable the OBD2 port?
Just something which isn’t controlled by the OBD II port. I think modifying the OBD-II port is complete overkill to deal with a possible theft issue. In addition to being a tricky issue as to how exactly to modify it, as the other answer points out, it may actually be illegal.
What’s the difference between OBD 1 and OBD 2?
It is also the primary location of tracking devices such as dongles as the port provides ongoing power to the device. There are two generations of OBD ports, OBD1 and OBD-ii aka OBD2. To determine which one you have, if your vehicle was built and sold in the US after January 1st, 1996 you will have an OBD 2 port.
What to do if the OBD II scanner doesn’t communicate with the vehicle?
What to do if the OBD II scanner doesn’t communicate with the vehicle. TEST 1: Connect the positive DMM lead to DLC pin 4 and the negative DMM lead to the negative battery terminal, using jumper wires if necessary. Do not connect to the body or chassis ground but to the battery terminal directly.