Where is the ignition coil on a 1998 GMC?
Locate the ignition coil on the driver’s side of the engine just above the valve cover and bolted to the intake manifold. Remove the large wire coming from the top of the coil. This is the high-tension connection and you can set the wire aside for now. Locate the wiring harness connector on the top of the coil.
Can a GM ignition control module be used?
The ignition control module (ICM) and ignition coil tests in this article assume that your vehicle is Cranking but NOT STARTING due to a NO SPARK Condition. If you’re GM car or truck starts and runs, this article will not help you.
What are the symptoms of a failing fuel pump driver module?
Symptoms of Failure Symptoms of a failing fuel-pump driver module all manifest in the performance of the engine. Difficulty in starting or a smoky start-up, stalling or uneven running while idling, hesitations and misses when driving, and power surges when in reverse can all — separately or together — be indicative of a failing module.
What was the ignition module for a 1996 GMC c2500?
1996 GMC C1500, C2500, C3500 Pick Up. 1996 GMC K1500, K2500, K3500 Pick Up. All of the information you need to diagnose a misfire or a no-start problem (caused by the ignition coil, the ignition module, or the crankshaft position sensor).
How to test a GMC fuel pump relay?
TEST 1: Swapping Out The Fuel Pump Relay. TEST 2: Making Sure The Fuel Pump Relay Has Power. TEST 3: Bypassing The Fuel Pump Relay. TEST 4: Bench Testing The Fuel Pump Relay. Fuel Pump Circuit Diagram. Where To Buy The Fuel Pump Relay. More GM 4.3L, 5.0L, and 5.7L Tutorials.
How to test a GM 4.3L fuel pump?
More GM 4.3L, 5.0L, and 5.7L Tutorials. It’s very important that you start off your fuel pump relay diagnostic by first testing the fuel pump pressure with a fuel pressure test gauge. If the fuel pump relay IS NOT activating the fuel pump, the fuel pressure test gauge will register 0 PSI when cranking the engine.
Locate the ignition coil on the driver’s side of the engine just above the valve cover and bolted to the intake manifold. Remove the large wire coming from the top of the coil. This is the high-tension connection and you can set the wire aside for now. Locate the wiring harness connector on the top of the coil.
Where is the fuel pump control module located?
It is often found in the fuse box located in the engine bay and functions as the primary electronic switch that controls power to the fuel pump. The fuel pump relay is usually controlled by the ignition or Powertrain Control Module , and when switched on, will provide current to the fuel pump so that it may function.