Where is the fuse on a Mercedes-Benz W203?
Twist screws (1) 90° counterclockwise. Slide-out retainer (3) and remove the cover by pulling towards the front. Install cover (2) in reverse order. It is on the left-hand side of the trunk. Japan version: VICS+ETC voltage supply separation point.
Why is the brake light switch on my Mercedes not working?
If you don’t see the letters on the cluster change from P to R to N, it is a good sign that the gear selector module is defective. You can buy a new brake light switch on Amazon for less than $15 USD, just do a search for Mercedes-Benz Brake Light Switches.
Why is the battery on my Mercedes Benz not working?
Hint: Starter Problem or Low Battery This may seem obvious, but an old battery is the root of many headaches and can cause all sorts of malfunctions on Mercedes-Benz cars. How old is the battery on your Mercedes-Benz?
What causes a Mercedes Benz to not start?
In most cases you will get a fault code related to one of the following: 1 ECM / PCM computer failure 2 Camshaft position sensor 3 Shifter Selector module 4 Fault codes related to driver authorization or immobilizer 5 Electrical problems
Twist screws (1) 90° counterclockwise. Slide-out retainer (3) and remove the cover by pulling towards the front. Install cover (2) in reverse order. It is on the left-hand side of the trunk. Japan version: VICS+ETC voltage supply separation point.
Where is the light switch on a Mercedes Benz?
You will need to open the driver side door to give you access to the T20 screw located under the parking brake handle as well as remove the access panel on the end of the dash. Begin by pulling the brake handle out. This will give you access to a single T20 Torx screw located under the handle.
Where are the T20 screws on a Mercedes Benz?
You will need to open the driver side door to give you access to the T20 screw located under the parking brake handle (red arrow) as well as remove the access panel on the end of the dash (yellow arrow). Begin by pulling the brake handle out. This will give you access to a single T20 Torx screw located under the handle.
Where are the fuses on a Mercedes medic?
Fuses 21-42 are located at the side of the dash. On the driver side. Fuses 1 through 20 are located in the trunk. Fuses 43-63 are located under the hood. Near the hood hinge on the driver’s side. Take a look at the pictures for the exact location.
What happens when a Mercedes Benz fuse is blown?
If a fuse has blown, the inside element will be melted. Blown fuses must be replaced with fuses of the same rating, which you can recognize by the color and value.
If you don’t see the letters on the cluster change from P to R to N, it is a good sign that the gear selector module is defective. You can buy a new brake light switch on Amazon for less than $15 USD, just do a search for Mercedes-Benz Brake Light Switches.
What should I do if my Mercedes fuse blows?
If a newly inserted fuse also blows, have the cause traced and rectified at a qualified specialist workshop, e.g. an authorized Mercedes-Benz Center. Before changing a fuse, secure the vehicle against rolling away and switch off all electrical consumers. Always disconnect the battery before servicing high current fuses.
Why is my Mercedes Benz gear shift stuck?
Gear shift stuck is one of the most common problems with Mercedes-Benz cars. Unfortunately, looking to see if the brake lights turns on while you press the brake pad, is not a good test to tell if the brake light switch is working properly.
What happens to the light sensor in a Mercedes Benz?
If there is rain on the windshield then some of the light will be refracted and spread by the rain drops and cause a low light signal back to the sensor. The more rain the more light that gets dispersed.
Where is the rain sensor on a Mercedes Benz?
The sensor is located under a plastic protective cover behind the rear view mirror and attached to the windshield (red arrow). Use a trim removal tool and gently pry the cover off the mount attached to the windshield (red arrow).
Can a Mercedes windshield wiper sensor be replaced?
If your Mercedes has the rain/light sensor for the windshield wipers and it starts acting up, changing out the sensor is quick and easy. The sensor is attached to the front windshield and can be replaced without removing the windshield.