Where is the fuel pump hose on a Volvo 240?
240 models with Bosch LH electronic fuel injection have a large plastic accordion style intake hose that connects the air mass meter to the intake manifold. This hose rests on the inner fender, over time a hole will wear through where it touches.
Are there any problems with the Volvo 240?
It commonly fails in the open position allowing super heated air to be drawn into the engine, which reduces performance as well as dramatically shortening the life of the expensive air mass meter. The seats in the 240 are very comfortable when they are in good condition. 240 seats offer excellent adjustable lumbar back support.
What kind of tank does a Volvo 240 have?
Volvo 240, a bulletproof tank. I had an 84 244DL, when I sold it to the neice of a friend it was running strong with original 350,000 miles. I replaced the alternator twice and the starter once.
Where is the fuse box on a Volvo 240?
Here’s a list of some of the most common issues to look out for on the 240 if you are thinking of picking one up for a project or daily driver. The main fuse box is located in the driver side kick panel and sufferes from a few design flaws.
Where is the air box thermostat located on a Volvo?
Also related to the intake system is the air box thermostat. This is a small valve located in the air box that routes hot air from the exhaust manifold to aid in cold start performance until the engine reaches normal operating temperature.
Where is the air intake on a Volvo 940?
Connections along this tube include: Idle Air Control Valve hose, PCV hose, intake box, throttle body. The flexible intake tube itself may also leak along the joints. The Volvo 940 has a thermostat just before the intake box which is normally open in warm weather.
Why does my Volvo 940 have a leak?
The flexible intake tube itself may also leak along the joints. The Volvo 940 has a thermostat just before the intake box which is normally open in warm weather. In cold weather, the valve closes and intake air is routed past the exhaust manifold in order to warm it up.
How do you replace a Volvo fuel tank pump?
Tighten all clamps (two on either side of the straight hose splice, and one where the spliced hose goes onto the 90-degree brass elbow. Then tighten the hose clamps on the short section of rubber hose around the send unit’s steel tube, and where that short section of hose, goes into the 90-degree elbow.
What kind of fuel injection does a Volvo 240 have?
For owners of 1982-89 non-turbo Volvo 240 series, Volvos with LH fuel injection. Here’s a chance to put an end to intermittent electrical problems with our watertight fuse holder system. With the Bosch® LH fuel injection system, current is supplied from the battery to an exposed blade style fuse.
What causes a Volvo 240 to overheat?
This is usually caused by a failed pre pump in the gas tank, which in turn causes the main fuel pump to be overworked and draw excessive amperage that overheats the circuit.You can confirm this failure by popping the cover off the relay and inspecting the solder joints on the circuit board.