Where is the fuel filter on a 2007 Honda Accord v6?
It looks like the fuel filter is located at the top of the fuel pump inside the gas tank, honda recommends to only change is when fuel pressure drops below specified value.
Where is the fuel filter located on a Honda Accord?
The fuel filter location is different on certain model years. 1990-1994: Accord fuel filters are located on the passenger’s side firewall. 1995-2002: Accord fuel filters are located on the rear of the engine, near the brake master cylinder.
How do you change the fuel line in a Honda Accord?
Screw the bottom fuel line into the bottom of the fuel filter. Tighten the fuel line nut with the 14mm open end wrench. Screw the top banjo bolt into the top of the fuel filter. Tighten the banjo bolt with the 17mm open end wrench. Slide the catch pan out from under the Accord.
What to do if you spill gas on your Honda Accord?
Place the fluid catch pan under this area to catch any spilled gas. Once the nut is removed, pull the lower fuel line off and set it aside. Then, use the 17 mm flare nut wrench to loosen the Banjo bolt on upper fuel line.
How do you replace a fuel filter clamp?
Unclip the alignment hole holding the top of the fuel filter in place, and then remove the fuel filter from the clamp. Dispose of the old filter and place the new fuel filter in the clamp. Then, insert the fuel filter clamp to its original location and secure it with the two 10 mm bolts. Figure 6. Remove and replace the fuel filter from the clamp.
What kind of fuel filter does a 1990 Honda Accord have?
The fuel filter on the 1990 Honda Accord is a two-port canister fuel filter. The main responsibility of the fuel filter is to keep any type of trash or fuel sediments from getting into the engine. The fuel filter prevents this by trapping the sediments inside of the elongated fibers that make up the inner filter.
How do you change the fuel line on a Honda Accord?
Place the fluid catch pan under this area to catch any spilled gas. Once the nut is removed, pull the lower fuel line off and set it aside. Then, use the 17 mm flare nut wrench to loosen the Banjo bolt on upper fuel line. Rotate the wrench counterclockwise to loosen the bolt, and then remove the fuel line by hand.
Place the fluid catch pan under this area to catch any spilled gas. Once the nut is removed, pull the lower fuel line off and set it aside. Then, use the 17 mm flare nut wrench to loosen the Banjo bolt on upper fuel line.
Unclip the alignment hole holding the top of the fuel filter in place, and then remove the fuel filter from the clamp. Dispose of the old filter and place the new fuel filter in the clamp. Then, insert the fuel filter clamp to its original location and secure it with the two 10 mm bolts. Figure 6. Remove and replace the fuel filter from the clamp.