Where is the EPS steering sensor located?
EPS is a relatively simple system. The steering shaft torque sensor, located in a section of torsion bar in between the steering input and output shafts, is the PSCM’s main input for determining steering direction and the amount of assist needed.
What happens when you turn off the ESP Bas light?
This should, with any luck, reset your steering angle sensor and get the sensor working in the way it’s supposed to again. It should also shut your ESP BAS light off and allow you to get back to going about your business.
Why does my Bas light come on in my Mercedes Benz?
To reset the lights, start up your Mercedes-Benz and turn the steering wheel all the way to the right, then all the way to the left. Do this a couple of times. Turn off the engine. Restart. Brake Light Switch may cause BAS / ESP / ABS light to come on. It is the most common problem with Mercedes-Benz cars.
Can a failed ABS sensor trigger the Bas light?
If you have an ABS sensor that has failed, it will also trigger the ABS, ESP, BAS light. Because the ESP system depends on the ABS system to function properly, the ESP system will also get disabled.
Is the ESP / Bas c2205 c1219 c123f related?
C1219, C123F appear to simply be related to C2205 and nothing seems to indicate any other sensor or any other parameters being exceed. Does your reader have freeze frame data?
What causes the ESP Bas light to come on?
Here are the most common causes of the ESP BAS light coming on: Steering Angle Sensor The steering angle sensor is one of, if not the most, common causes of the ESP BAS light to come on. As mentioned above, make sure to turn the steering wheel twice to the right, twice to the left, and finally back to the center.
Why does the ESP Bas light come on on my Jeep Wrangler?
Steering Angle Sensor The steering angle sensor is one of, if not the most, common causes of the ESP BAS light to come on. As mentioned above, make sure to turn the steering wheel twice to the right, twice to the left, and finally back to the center. This resets the steering angle sensor in your Wrangler.
To reset the lights, start up your Mercedes-Benz and turn the steering wheel all the way to the right, then all the way to the left. Do this a couple of times. Turn off the engine. Restart. Brake Light Switch may cause BAS / ESP / ABS light to come on. It is the most common problem with Mercedes-Benz cars.
C1219, C123F appear to simply be related to C2205 and nothing seems to indicate any other sensor or any other parameters being exceed. Does your reader have freeze frame data?