Where is the diagnostic connector on a Honda Accord?
you will find several photos allowing you to find your way around the cabin. The diagnostic connector is on the side of the center console (at the feet of the passenger) The connector is non-standard, the 3-way blue connector is the diagnostic connector, the 2-way connector is the service connector (fault reading without scanner)
How can I Find my OBD plug in my car?
To diagnose your vehicle yourself, download our EOBD-Facile car diagnostic software. Use our search engine below to locate your OBD2 port! You will find below several pictures which will help you find your OBD connector in your car.
Where is the OBD connector on a Honda CRV?
Where’s the OBD connector location on Honda CR-V (1996 – 2001)? you will find several photos allowing you to find your way around the cabin. The diagnostic connector is on the side of the center console (at the feet of the passenger)
Where are the diagnostic connectors in a Nissan?
Locations: In the center console. Locations: In or next to the fusebox under the dash panel. In the center console. Locations: Under the drivers seat. Under the passengers seat. Above the passengers side kick panel. In the center console.
Where is the OBD plug on a Honda?
– Have the ignition key in OFF position. – Connect the OBD tool connector to the 4-pole RED DLC plug of the bike, and connect the USB plug to your Windows PC. Warning: Never connect the OBD tool connector to a bike plug other than the RED plug.
Where are the Honda engine diagnostic connectors located?
Locations: Under the drivers side dash panel. Inside or below the glovebox. Locations: Under the passengers seat. Above the passengers side kick panel. In the center console. Locations: Under the drivers seat. Under the passengers seat. Under passengers floor carpet or flap in carpet.
Where is the OBD II diagnostic port on a car?
All vehicles sold in the United States from 1996 and after were mandated to haven an OB II diagnostic port installed by the manufacturer. The port on the car it typically black or white. If you are having a difficult time locating the OBD II port use the OBDII port locator here.
How to connect OBD tool to red plug?
Warning: Never connect the OBD tool connector to a bike plug other than the RED plug. – Start the OBD tool application. – Select neutral, turn ignition On and have the engine stop switch in RUN position. – Press the “Connect” button.