Where is the air flap on a Mercedes p2005?
P2005 – Intake Manifold Runner Control Stuck Open Bank 2 To fix this problem you will need to replace the intake manifold air flap lever using Repair Kit 2721402401. This part is located by the intake manifold.
What kind of intake manifold does Mercedes Benz use?
Mercedes Benz 3.0 and 3.5-liter V6 and V8 engines ( M272 and M273) are fitted with a variable intake manifold that includes a set of long and short runners. Mercedes has used a series of flaps and an actuating mechanism to bridge these runners, changing the distance air needs to travel to reach intake valves.
What to do if your Mercedes air flap runner is broken?
An aluminum part is less likely to fail again and is much better solution than the plastic OEM lever. The least expensive solution is to replace the broken Mercedes Benz M272/M273 Intake Manifold Air Flap Runner using a repair kit. Note that in the past dealers did not sell the lever only but sold a complete intake manifold.
How do you remove the intake manifold from a Mercedes P2004?
Instructions Remove the intake manifold from the engine. Remove the vacuum actuator rod by pushing it out of the lever using a flat screwdriver. Next use a T30 Torx bit to remove the bolt that holds the lever. Install the central bolt. Place some grease on the ball studs and then press the connecting rod until it locks in the ball studs.
P2005 – Intake Manifold Runner Control Stuck Open Bank 2 To fix this problem you will need to replace the intake manifold air flap lever using Repair Kit 2721402401. This part is located by the intake manifold.
What kind of intake manifold for Mercedes E350?
Pages with related products. See and discover other items: intake manifold, aluminum intakes, for mercedes e350, gasket mercedes, intake manifolds, Small Intake Manifolds
What should I do if my Mercedes intake manifold is broken?
The least expensive solution is to replace the broken Mercedes Benz M272/M273 Intake Manifold Air Flap Runner using a repair kit. Note that in the past dealers did not sell the lever only but sold a complete intake manifold. Buying a new intake manifold is too expensive and NOT necessary.
An aluminum part is less likely to fail again and is much better solution than the plastic OEM lever. The least expensive solution is to replace the broken Mercedes Benz M272/M273 Intake Manifold Air Flap Runner using a repair kit. Note that in the past dealers did not sell the lever only but sold a complete intake manifold.