Where is the adjuster screw on a brake drum?
Turn the brake drum so that the access hole is aligned with the drum’s adjuster screw. The adjuster screw is large and slotted, and is located beneath just beneath the centerline that runs horizontally across the back of the drum. Turn the adjuster screw counterclockwise until it comes to a halt.
How are drum brakes used in a car?
Drum brakes (as opposed to disc brakes) are a braking system that slows a vehicle by pressing brake shoes into the inside surface of a metal drum attached to the wheel to create friction.
Where is the access hole on a brake drum?
Locate the access hole on the outside of the brake drum. Turn the brake drum so that the access hole is aligned with the drum’s adjuster screw. The adjuster screw is large and slotted, and is located beneath just beneath the centerline that runs horizontally across the back of the drum.
How do you replace a leaky brake line?
If necessary, replace the leaky wheel cylinder. Loosen the brake line connected to it, then loosen the bolts at the rear of the cylinder. Insert the new cylinder into its proper place, attach the brake fitting, then the brake line, then finally re-screw the bolts.
How to remove a brake drum that is stuck on?
Watch how to remove a brake drum that is stuck on. I go through the steps so anyone can remove their drum brake. In this case the drum adjuster was stuck so first try to get it off by wiggling back and forth. Then spray penetrating oil to remove rust between the drum and the seat. Then hit it with a hammer hard.
Turn the brake drum so that the access hole is aligned with the drum’s adjuster screw. The adjuster screw is large and slotted, and is located beneath just beneath the centerline that runs horizontally across the back of the drum. Turn the adjuster screw counterclockwise until it comes to a halt.
How is a brake drum puller attached to a wheel?
Place each of the brake drum puller’s 3 hooks evenly around the brake drum’s flange. Ensure that the screw in the middle of the brake drum puller lies above the middle of the wheel hub. Use a screwdriver to attach the brake drum puller’s screw tightly. Tighten the screw until the brake drum puller is securely fastened around the brake drum.
What happens when you change the drum on a car?
Most drum brakes on cars and other common vehicles are hydraulically powered. If there is a leak in the hydraulic system, you may notice fluid inside the drum and on the brake shoes. Usually, this is accompanied by decreased brake performance. If necessary, replace the leaky wheel cylinder.