Where is the ABS pump on the ML W163?
If you look at your fuse box it will be marked ABS Pump or ABS Motor or 4EPS. On the ML W163 it is K25. Located under the hood, in front of the driver. Manually get the ABS motor to run by jumping the wires on ABS Relay socket.
How to fix ABS motor on Mercedes medic?
Be careful not to pull that out with the ABS motor. If you pull the ABS motor ½ inch out then put a long screwdriver in the gap pointing toward the shaft of the motor. This will help and will avoid the cap coming out with the motor. Remove rotor from motor housing. A couple of methods:
Where is the ABS pump on a Mercedes Benz?
Diagnostic Steps: Locate the ABS pump on your Mercedes Benz. On the ML it is located on the front left behind the driver’s side headlight. Next to the washer fluid reservoir. Find the relay that runs the ABS pump. If you look at your fuse box it will be marked ABS Pump or ABS Motor or 4EPS. On the ML W163 it is K25.
Why is my ABS sensor not working properly?
If you replaced the wheel speed sensor and are still getting the same error related to wheel speed sensor failure, the wires to the sensor may be damaged, or the ABS Control unit is the problem. One way to confirm that the sensor itself is the problem and not the wires or the ABS module is to read the codes.
How to repair ABS pump on Mercedes ML?
Unscrew the bolts that hold the pump to ABS control valve unit. Two T25 torx bolds on each side of the motor in the ML. Be careful not to strip them. They strip easily, don’t ask how I know. Pull the ABS motor straight out. At the center of the ABS module there is an O “cap” metal ring. Be careful not to pull that out with the ABS motor.
When does the ABS module set the OBDII code?
The ABS Module monitors the ABS Hydraulic Pump Motor. The ABS Module sets the OBDII code when the ABS Hydraulic Pump Motor is not to factory specifications. Need more information on how to fix the C1095 FORD code?
Where is the ABS relay on the ML W163?
Find the relay that runs the ABS pump. If you look at your fuse box it will be marked ABS Pump or ABS Motor or 4EPS. On the ML W163 it is K25. Located under the hood, in front of the driver. Manually get the ABS motor to run by jumping the wires on ABS Relay socket. If the ABS motor doesn’t run when you jump the relay then move to the next section.
How much does it cost to repair ABS on ml W163?
On this DIY article we will focus on repairing the ABS motor (4ESP). This repair could cost around $3,000 at the dealer or around $2,000 at an auto repair shop. If you have some DIY repair skills then you are looking at about $20. That’s right $20. This is a very common problem on ML W163.