Where does the installation of a convertible top begin?
The installation of a new top is the reverse of the removal process. This is described with photos and illustrations in the full manual. The installation of the new top begins at the trim stick and ends at the header bow. View of bolts holding trim sticks to car. From inside car under back window. This document is property of M & T Manufacturing.
How do you install a new car top?
The installation of a new top is the reverse of the removal process. This is described with photos and illustrations in the full manual. The installation of the new top begins at the trim stick and ends at the header bow. View of bolts holding trim sticks to car. From inside car under back window.
How do you remove a convertible top from a car?
Both methods are fully covered in the manual. The removal process begins by orienting the top to best access the header bow. A front seal or welting strip is pulled off (covered in detail in the full manual.) Staples are pried off of the underneath of the bow and the fabric peeled off of the header bow.
Where is the tacking strip on a convertible top?
In other words: on the rear top bow there are two rows of staples: the upper row holds the back edge of the main top, and the lower row holds the top edge of the curtain. Embedded into the rear top bow is a long tacking strip. It is attached to a groove in the bow with rivets.
How long does it take to install a convertible top?
Total install time is over 30 hours for a first timer. Be prepared and BE PATIENT. This is a frustrating and fragile process, and the directions are usually not very clear. Also, every time you remove a part, you’ll find another issue underneath it.
Where is the stitching on a convertible top?
If you look closely, there is a second row of stitching behind the tops lip. It is towards the rear of the rear side window. This row of stitching helps maintain a decorative lip which covers the weatherstripping and reduces wind.
Is the convertible top on my Cutlass original?
It also touches on repairing the frame, tacking strip, and trunk areas. The top on our Cutlass was believed to be original to the car, and certainly had a number of issues.
What do I need for a convertible top?
In addition to your top package, you may need the following: Weatherstripping condition – mine was shot. Rain gutter condition – Located in trunk and drains water away. Mine was broken. Replacement gutters are hard to find and cost over $200.