Where does the brake line go on a Silverado?
On the ABS pump the 2 lower line ports for the master cylinder are labeled front input for the left hole and rear input for the right hole. This is correct BUT on the master the front line goes to the rear brakes and the rear line goes to the front brakes.
How to post a brake line routing diagram?
To post the picture, try this: Get the image on your screen, and then hold down “Control” and press “print screen” – which is located to the right of F12. Then open Microsoft paint, and select “Paste”. Now just save the file to the desktop, and upload to the site.
How to disconnect brake line from front skid plate?
Take the left wheel liner and the front skid plate out to make it easier and disconnect it from the brake line at the wheel. When you’re sure that it’s all clear of any hold downs, you can pull it out from the bottom front, I did it a little at a time from each side.
Are there brake lines on new GM trucks?
GM said there is no trouble with their brake lines, but on new trucks they are plastic coated, just like the two lines going to my rear wheel cylinders on my 2006 Sierra. I would have tried the ‘print screen’ idea, but alas, I have no MS paint.
Where do the brake lines go on a GMC Sierra?
I have a 2006 GMC Sierra 4 x 4 Crew cab SLE. My lines are the tc04 727. They DO NOT go into the ports like everything I’ve seen says. The only diagram I gave found is from dealership or nemigaparts. It does not clearly show proper routing/port locations.
Where do the 5 brake lines go in an ABS module?
Disconnect the 5 brake lines from the brake pressure modulator valve (BPMV). When looking at the brake pipe port face of the BPMV, the ports are assigned as follows: Upper Left–Left Front Output Upper Middle–Right Front Output Upper Right–Rear Output Lower Left–Master Cylinder Secondary/Front Input
When did I replace the brake line on my Silverado?
I had the brake line rust through going to the right front last week. 99 Silverado 2500 (no HD), that I had bought in 2010. While replacing the line I noticed 3 other brake lines had already been replaced, which kind of surprised me a bit, seeing very little other rust under there. It wasn’t a fun job for sure, doing it on a creeper, with no lift.
To post the picture, try this: Get the image on your screen, and then hold down “Control” and press “print screen” – which is located to the right of F12. Then open Microsoft paint, and select “Paste”. Now just save the file to the desktop, and upload to the site.