Where do you place the sleeve on a SKF shaft?
Determine where the sleeve must be positioned to cover the seal wear track. Measure to the exact point, or mark directly on the surface. The sleeve must be placed over the worn area, not just bottomed or left flush with the end of the shaft.
How do you install a SPEEDI sleeve on a shaft?
The same size seal (as the one being replaced) fits snugly onto the new surface. And each SPEEDI-SLEEVE comes as a kit with a disposable installation tool. Clean the seal counter surface on the shaft. File down any burrs or rough spots. Measure the diameter where the sleeve will be positioned on an unworn portion of the shaft (see fig. 1).
How do you Mount A J shaft gearbox?
1. Mount the inner bushing with the nut in its outer position. The bushing shall be mounted against the shoulder or circlip. Where the shoulder should not exceed inside of nut. 2. Put the key in the keyway. 3. Mount the reducer on the machine shaft and press it against the inner bushing.
What kind of filler to use on SKF sleeve?
Clean away sealant that migrates to the shaft or sleeve outside diameter surface. If the shaft is deeply scored (see note above) fill the groove with a powdered metal epoxy type filler*. Install the sleeve before the filler hardens, allowing the sleeve to wipe off any excess filler.
Determine where the sleeve must be positioned to cover the seal wear track. Measure to the exact point, or mark directly on the surface. The sleeve must be placed over the worn area, not just bottomed or left flush with the end of the shaft.
How to write a KX250F motorcycle service manual?
KX250F Motorcycle Service Manual This quick reference guide will assist you in locating a desired topic or pro- cedure. •Bend the pages back to match the black tab of the desired chapter num- ber with the black tab on the edge at each table of contents page.
The same size seal (as the one being replaced) fits snugly onto the new surface. And each SPEEDI-SLEEVE comes as a kit with a disposable installation tool. Clean the seal counter surface on the shaft. File down any burrs or rough spots. Measure the diameter where the sleeve will be positioned on an unworn portion of the shaft (see fig. 1).
Clean away sealant that migrates to the shaft or sleeve outside diameter surface. If the shaft is deeply scored (see note above) fill the groove with a powdered metal epoxy type filler*. Install the sleeve before the filler hardens, allowing the sleeve to wipe off any excess filler.