Where do the bearings come from on a Saturn Vue?
The Saturn Vue employs both front and rear wheel hub bearing assemblies. These assemblies come from the factory complete with unserviceable bearings already pressed into the hub. They require no lubrication since they are sealed units.
How do you replace a front wheel hub on a Saturn Ion?
Remove the brake rotor. If rusted in place, apply hammer blows to the center of the rotor until the vibration breaks loose the rust. Remove the CV axle nut using an impact tool and a 30 mm 6-point socket. Push the CV axle shaft through the wheel hub with some light hammer blows to the shaft.
What to do if your front wheel hub is stuck?
Push the CV axle shaft through the wheel hub with some light hammer blows to the shaft. If the shaft is stuck due to rust, use either a punch tool centered on the middle of the shaft and apply hammer blows or use a punch attached to an air or electric hammer tool.
How do you remove steering knuckle from Saturn Ion?
Remove the two (2) nuts and bolts that holds the steering knuckle to the suspension strut. The bolts have splines and must be hammered out of the steering knuckle. Protect the bolt threads by keeping the bolt’s nut on the end of the bolt threads. Detach the steering knuckle from the suspension strut. A pry bar can help with the removal.
Where are the wheel bearings on a car?
This is because the front rotors are often behind the front hubs, which means that to change the rotors you have to pull the hubs off the front spindles, at which point the bearings are practically in your hand. So, if you need to do a front brake job, check the wheel bearings.
What’s the best way to lubricate a wheel bearing?
Put a large dollop of grease into one hand and scoop grease into the large side of the bearing, making sure the grease gets inside. Synthetic grease offers superior lubrication protection.
What can cause wheel bearings to wear down?
However, they can be damaged. They are especially vulnerable if you hit a pothole, tall curb, or a speed bump at a brisk speed. If water, mud, road salt, or sand get past the seal and touch the bearings, it will contaminate the grease, causing the bearings to prematurely wear down, eventually leading to failure.
How do you remove a hub cap from a tire?
Remove the hub cap or center cap from the tire in question if applicable. Break the lug nuts loose 1/8 of a turn counterclockwise with the lug wrench. Break the spindle nut loose one full turn with the breaker bar and a 34-mm spindle nut socket for a front bearing or a 30-mm spindle nut socket for a rear bearing.
How to replace front wheel bearings on Saturn Ion?
Remove the two (2) brake caliper bracket bolts and remove the brake caliper bracket. Remove the brake rotor. If rusted in place, apply hammer blows to the center of the rotor until the vibration breaks loose the rust. Remove the CV axle nut using an impact tool and a 30 mm 6-point socket.
Push the CV axle shaft through the wheel hub with some light hammer blows to the shaft. If the shaft is stuck due to rust, use either a punch tool centered on the middle of the shaft and apply hammer blows or use a punch attached to an air or electric hammer tool.
Remove the two (2) nuts and bolts that holds the steering knuckle to the suspension strut. The bolts have splines and must be hammered out of the steering knuckle. Protect the bolt threads by keeping the bolt’s nut on the end of the bolt threads. Detach the steering knuckle from the suspension strut. A pry bar can help with the removal.