Where do I replace the dome light on my Ford Ranger?
Replacement dome light bulbs are available from auto parts and hardware stores. Place the truck’s automatic transmission shift lever into the park (“P”) position, or place the shifter in first gear if your Ranger has a manual transmission. Apply the emergency brake and shut down the engine.
How to replace the brake light on your car?
How to Replace a Brake Light Switch. Step 1 – Find the Brake Light Switch. The brake light switch is often found in the same location on all vehicles. You will need to open the driver Step 2 – Access the Brake Light Switch. Step 3 – Remove the Brake Light Switch. Step 4 – Replace the Brake Light …
How to replace tail light lens on Ford Ranger?
Sanstrom has undergone advanced automotive training at the Dunwoody College of Technology, holds an Associate of Arts in general studies from Century College and has more than 10 years of experience in all aspects of automotive repair and diagnosis. How to Remove a Tail Light Lens on a …
How do you reset an anti lock brake light?
Disconnect the positive cable from the car battery, and then hold down on the brake pedal to drain the car’s electrical system. This will reset the car’s central computer. Plug the positive cable back to restore the power. Even if this doesn’t totally reset the light, it should stay off for up to 1 week.
What are the bulbs on a Ford Ranger?
Or, you could check the Bulb Replacement Guide to identify the bulbs in your vehicle. High beam headlight & Low beam headlight: 9007 Front turn signal light ( blinker light) for 1988-2011: 3457 / 3457K / 3157 / 3157K / 3157A / 3157AK / 3157-SCK ( parking light) Rear turn signal light / Brake Tail light: 4157 / 4157K / 3157 / 3157K / 3156 / 3156K
How do you change the brake light switch?
Rotate the switch in the clockwise direction to lock it in place. Note: While installing the switch you may have to press down on the brake pedal in order to insert it all the way. Step 3: Reconnect the battery. Now that the new switch is installed, reconnect the wiring harness and negative cable on the battery.
What to do if your brake light does not work?
Press down on the brake pedal and see if the lights illuminate. Note: On the newer style switch, you will not need to adjust anything and the lights should work after installation. If the lights do not work even after adjustment, a certified technician would be able to inspect the switch and diagnose the problem.
Where are the brake lights on a car?
The brake lights of your car are controlled by switches connected to the brake pedal underneath the steering wheel. These switches are very small and tend to wear out or fail after extended use. Faulty switches in turn prevent your car’s brake lights from working properly.