Where can I get parts for my master heater?
This part is sourced directly from Pro Temp and is an OEM approved replacement part for certain Kerosene/Diesel Forced Air Heaters manufactured by Pro Temp, Heat Hog, Heat Stream, and Master. For full compatibility, please see the “Model Cross Reference List” below.
Why is my direct fired heater not working?
If you’re renting a direct fired heater that isn’t working, and want to save yourself a trip from a service technician, there are a few things you can check first. The most common problems that can be easily solved are, no electrical source, no fuel source, dirty spark plug, and dirty flame sensor rod.
How to fix a heater blower and heat element?
Removed the one nut that was holding the old foot on and replaced it with the new foot bracket (which includes the wheels), and fastened it on with u-bolt and nut. read more Took off light cover took out heater blower and heat element.
Why is the flame sensor on my heater not working?
After tipping your heater up, you’ll see the flame sensor rod at the top of the direct fired heater. It will probably be corroded and dirty, which is the reason the heater won’t stay lit. Take your sand paper or emery cloth and clean off the rod of all dirt and corrosion.
What to do if your direct fired heater is not working?
First, turn off your heater and unplug it from your power source. Tip the heater so the barrel faces upward. Take your wire brush and clean the black residue off of the spark plug. Once the residue is cleaned off, tip your heater back down and plug it into your power source.
What to do if your heating system does not turn on?
Using a digital ohmmeter throughout the installation process will ensure the heating cable stays in good working order. Issue 1: The heating system will not turn on. One of the most frustrating things an installer can face is completing a floor-heating installation and experiencing a failure in the system.
What are the most common floor heating issues?
Verify the capacity of your electrical panel before you begin installing your floor-heating system. Issue 2: The thermostat is overheating. A scary issue to run into after installation is a thermostat that overheats or even melts when the radiant heating system is turned on. This is generally caused by overloading the circuit.
Why is my gas heater not turning on?
If all of your valves are turned on and you still have fuel, the last thing you’ll want to check out is your fuel hose. If your hose is kinked anywhere it could be stopping the flow of fuel to your heater. After checking your valves, fuel source and hose, start your heater back up again.