Where can I find the Yamaha Virago online service manual?
Also covers 1988-2003 Yamaha XV535 International Models (non US market) Access the Yamaha XV535 Virago Online Motorcycle Manual NOW by CLICKING HERE – No waiting, no shipping, view it from anywhere, print it out – take it to the garage.
What causes the stator on a Yamaha Virago to fail?
Stator Failure: As the regulator, the stator is a critical part, and since they’re an older bike, owners of a Yamaha Virago should be inspecting their stators constantly. Some suggest years exposing the stator to pronounced heat and vibration may be the reason for the failure.
What kind of windshield does a Yamaha Virago use?
Choose from traditional windshields made from Lexan Polycarbonate with a Quantum™ hardcoat or stealth streamers made from tinted acrylic. You may also want to cover up unsightly Yamaha Virago OEM parts like that black horn with a precision-machined chrome cover.
Why is my Yamaha Virago bike running rough?
The Bike Isn’t Running Well One of the chief complaints you hear about with the Yamaha Virago is bikes running rough— by sputtering, jerking, and lurching. In worse cases, riders have experienced a stall when the bike cuts out completely. The likeliest factor responsible for the running problems is an unkept fuel system.
How to remove carbs from a Yamaha Virago?
Remove rear inside stub bolt Slide carbs forward and from the right side of the bike, using a 10mm open end wrench. Remove rear outside stub bolt This was the first stub bolt you loosened. Remove rear intake stub Move the carbs out of the way and remove the stub.
How do you remove fuel lines from a virago?
Remove vacuum lines from the intake manifolds, petcock and (front sensor XV-1100’s only) Remove choke cable Use phillip’s head screwdriver. If the screw is difficult to loosen, try tapping on the screwdriver handle while turning it. Remove fuel lines from carbs Place a rag under the carbs to catch any fuel that may leak out.
Where are the head bolts on a virago?
Remove seat These bolts are 5mm allen head bolts. They are located under the front of the seat. Beware, there is a spacer on the left side and it may fall when the bolt is removed. Remove 12mm tank bolt The XV-750 tank comes off easily. Leave the petcock on “run”. Disconnect fuel, vacuum, vapor lines, and wire to the fuel sender.
How do you remove intake stubs from a virago?
Remove front outside intake stub bolt. Use 10mm open end wrench and remove bolt. Remove front intake stub The intake stubs are slotted on the inside to allow for removal. Hold the carbs out of the way and gently remove the intake stub. Be careful, there is an “O” ring on the back side of each intake stub.