Where can I find the OBD port?
The OBD-II port is usually located under the dashboard, beneath the steering wheel column (1 – 3 in the diagram below).
What is the OBD port used for?
The OBD Port, is the location where you can plug in any OBD tool into the vehicle to pull vehicle information. It is also the primary location of tracking devices such as dongles as the port provides ongoing power to the device. There are two generations of OBD ports, OBD1 and OBD-ii aka OBD2.
Where is the diagnostic port on a car?
Depending on the make and model, it may or may not be easy to locate. In some models it is located in the center console or on the passenger side of dash. All vehicles sold in the United States from 1996 and after were mandated to haven an OB II diagnostic port installed by the manufacturer. The port on the car it typically black or white.
What can I do with loose diagnostic terminals?
The 3 loose terminals above are also really useful for accessing some diagnostic connector terminals that are hard to get to. You can simply push the into / onto the diagnostic terminals and then hold or clip you LED tester or Voltmeter leads onto the terminals.
What does code 12 mean on ground terminals?
Ground terminals A and B (see diagram below) with the ignition “ON” and engine not running. The system will enter the diagnostic mode. In this mode, the computer will display a Code 12, three consecutive times, by flashing the “CHECK ENGINE”, “SERVICE ENGINE SOON” or “MALFUNCTION INDICATOR LAMP” or light.
Where are the OBD I trouble codes stored?
Reading the On/Off Flashes of the Check Engine Light. Location Of The Diagnostic Link Connector (DLC). Toyota OBD I Diagnostic Trouble Code Definitions. In a nutshell, to get the trouble codes stored in your Camry’s fuel injection computers’s memory, we need to jumper together 2 specific terminals of the diagnostic link connector (DLC).
Depending on the make and model, it may or may not be easy to locate. In some models it is located in the center console or on the passenger side of dash. All vehicles sold in the United States from 1996 and after were mandated to haven an OB II diagnostic port installed by the manufacturer. The port on the car it typically black or white.
The 3 loose terminals above are also really useful for accessing some diagnostic connector terminals that are hard to get to. You can simply push the into / onto the diagnostic terminals and then hold or clip you LED tester or Voltmeter leads onto the terminals.
Where is the diagnostic connector on a Kawasaki?
1. Locate the 4-pin Diagnostic Connector, which is located next to the battery in the front storage compartment. The connector is black on the 2007-2009 models, and white on the 2010-2012 models: 2. Remove the dust cap from the connector, and attach the Main Diagnostic cable to the diagnostic connector.
Ground terminals A and B (see diagram below) with the ignition “ON” and engine not running. The system will enter the diagnostic mode. In this mode, the computer will display a Code 12, three consecutive times, by flashing the “CHECK ENGINE”, “SERVICE ENGINE SOON” or “MALFUNCTION INDICATOR LAMP” or light.